Craig,
The only place I find the phrase "Incoming data=" is the following:
bin/mh:4277: print_log "X10: Incoming data=$event_data" if
$config_parms{x10_errata} >= 4;
It seems that so long as you have not defined x10_errata or have defined it to a value < 4
then you should not get those logs.
This is the definition in mh.ini:
@ This defines how much incoming X10 data you want echoed to the print log:
@ 1 -> no data
@ 2 -> Errata on incoming data
@ 3 -> " and notes dim, all on/off, merged, and duplicate X10 data
@ 4 -> " and echos all incoming and outgoing data
x10_errata=2
You may have redefined it in your private ini file to 4. Setting it to 3 or less should
eliminate the log message.
Sincerely,
Michael
From: Craig Lindholm [mailto:344...@gm...]
Sent: Saturday, June 22, 2013 1:13 AM
To: mis...@li...
Subject: [mh] Print Log
In my print log, I always get two entry's for my x10 events such as shown below:
06/21/13 10:25:40 PM X10: Incoming data=XA1AK
06/21/13 10:25:40 PM XA1AK: Kitchen_MS off
Is there any way to hide the first entry (Incoming data=XA1AK)?
Craig
Ver. 2.200
|
