Scribd
Upload
115 views1 page

InduinoX Board Manual

The document provides a pin mapping for an InduinoX board. It lists the RGB LED pins for red, green, and blue PWM signals as well as an LDR connected to analog pin 3. It then explains how to use jumpers to turn devices on and off by connecting the jumper between the left-most and middle pins to turn on and the right-most and middle pins to turn off. The rest of the document maps other pins including the VE terminal, SDA/SCL pins for the DS1307, and various digital and analog pins.

Uploaded by

aloove66
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
115 views1 page

InduinoX Board Manual

The document provides a pin mapping for an InduinoX board. It lists the RGB LED pins for red, green, and blue PWM signals as well as an LDR connected to analog pin 3. It then explains how to use jumpers to turn devices on and off by connecting the jumper between the left-most and middle pins to turn on and the right-most and middle pins to turn off. The rest of the document maps other pins including the VE terminal, SDA/SCL pins for the DS1307, and various digital and analog pins.

Uploaded by

aloove66
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd

RGB LED RED PWM PIN 3

LDR on Analog 3

BLUE PWM PIN 6

GREEN PWM PIN 5

This is How the Jumpers Work To Use any device turn on the jumper next to it. To Turn on a jumper connect the jumper between the LEFT most & MIDDLE of the 3 PINS. And to Turn it off connect the jumper between the RIGHT most & MIDDLE of the 3 Pins

Ve Terminal

SDA/SCL for DS1307

Terminal

Digital 15 TSOP IR Reciever

V in

InduinoX Board Pin Mapping

Digital 14 IR LED Digital 7 Digital Digital 8 9 Digital Digital 11 12 Digital 13

Ground These Six pins are the Power Rails to provide supply /ground for external connections Ground 5 Volts 3.3 Volts Reset

You might also like