Scribd
Upload
71 views1 page

A36 Steel Tension Member Design

This document describes selecting a single-angle tension member of A36 steel to resist various service loads. The member must withstand a dead load of 22 kN, live load of 44.5 kN, and wind load of 20 kN. It will be connected through one leg with 25-mm diameter bolts in two lines.

Uploaded by

Edzon Lacay
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
71 views1 page

A36 Steel Tension Member Design

This document describes selecting a single-angle tension member of A36 steel to resist various service loads. The member must withstand a dead load of 22 kN, live load of 44.5 kN, and wind load of 20 kN. It will be connected through one leg with 25-mm diameter bolts in two lines.

Uploaded by

Edzon Lacay
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd

Problem no.

3
Select a single-angle tension member of A36 steel to resist the following
service loads: dead load = 22 kN, live load = 44.5 kN, and wind load = 20 Kn. The
member will be connected through one leg with 25-mm diameter bolts in two lines.
There will be

You might also like