Scribd
Upload
45 views2 pages

Connector Maintenance and Specifications Guide

This document contains multiple choice questions and answers about connectors, cables, and technical drawings. Key details include that glycol de-icer fluid can cause corrosion when in contact with silver cables, rear release connectors are released from the rear and extracted from the rear, and the maximum operating temperature for nickel plated copper or aluminum connectors is 260°C. It also addresses gauges of pins that various colored plastic tools would be used on and definitions of abbreviations like A/F meaning Across Flats.

Uploaded by

Law Qianhan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
45 views2 pages

Connector Maintenance and Specifications Guide

This document contains multiple choice questions and answers about connectors, cables, and technical drawings. Key details include that glycol de-icer fluid can cause corrosion when in contact with silver cables, rear release connectors are released from the rear and extracted from the rear, and the maximum operating temperature for nickel plated copper or aluminum connectors is 260°C. It also addresses gauges of pins that various colored plastic tools would be used on and definitions of abbreviations like A/F meaning Across Flats.

Uploaded by

Law Qianhan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd

# a) it should be run over the finger through 180

o
and checked for smoothness and kinksb) move each link individually
and check for tightnessc) lay on a flat surface and check for kinks83.
Glycol de-icer fluid in contact with a silver cable can causea)
corrosion# b) a firec) disintegration of the cable insulation84. with a
rear release connecter, the pin will bea) released from the front and
extracted from the rear# b) released from the rear and extracted
from the rearc) released from the rear and extracted from the
front85. The maximum operating temperature for a nickel plated
copper or aluminium connector is
a) 135
o
C
b) 200
o
C
# c) 260
o
C
86. What gauge of pin would a yellow plastic insert / extract tool be
used on?
# a) 12 - 10b) 22 - 18c) 16 - 14Page 10 - Mod 7
87. Can the insulation grip be adjusted on a PIDG crimp tool?
a) Nob) Yes by turning a knob# c) Yes by adjusting the pins
88. The abbreviation A/F means
a) American Fineb) Associated Fine# c) Across Flats

89. This drawing indicates

# a) a blind holeb) a countersunk holec) a counterbored hole90. The


width of a visible outline on a drawing isa) 0.3 mmb) 0.5
mm# c) 0.7 mm91. What gauge of pin would a red plastic insert /
extract tool be used on?a) 12 - 10# b) 22 - 18c) 16 - 14

You might also like