Scribd
Upload
244 views2 pages

Bowline and Fisherman's Knot Guide

The document provides instructions for tying four different knots: 1. The bowline knot is used to form a fixed loop that will not tighten under load and is commonly used in sailing. 2. The bowline on a bite forms a secure loop in the middle of a rope that does not slip. 3. The figure eight knot keeps the end of a rope from running out of a tackle or pulley. 4. The fisherman's bend ties two ropes together securely using overhand knots on each rope.

Uploaded by

lola12367
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
244 views2 pages

Bowline and Fisherman's Knot Guide

The document provides instructions for tying four different knots: 1. The bowline knot is used to form a fixed loop that will not tighten under load and is commonly used in sailing. 2. The bowline on a bite forms a secure loop in the middle of a rope that does not slip. 3. The figure eight knot keeps the end of a rope from running out of a tackle or pulley. 4. The fisherman's bend ties two ropes together securely using overhand knots on each rope.

Uploaded by

lola12367
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
  • Figure Eight
  • Bowline
  • Bowline on a Bight
  • Fisherman’s Bend

Bowline This knot doesn't jam or slip when tied properly.

It can be tied around a person's waist and used to lift him, because the loop will not tighten under load. In sailing, the bowline is used to tie a halyard to a sail head. 1. Make the overhand loop with the end held toward you, then pass end through loop. 2. Now pass end up behind the standing part, then down through the loop again. 3. Draw up tight.

Bowline on a BiteUse: This makes a secure loop in the middle of a rope which does not slip. A bight is the middle part of the rope (not the ends) 1. 2. 3. 4. 5. 6. In the middle of a rope, form a small loop. Thread the bight through the loop. Spread out the bight a little. Pass this down and around the whole knot. Continue until it come back to the neck where it started. Tighten the bight to complete the knot. Tighten carefully so that you don't get a kind of slip knot.

Figure Eight: This knot is ideal for keeping the end of a rope from running out of tackle or pulley. 1. Make underhand loop, bringing end around and over the standing part. 2. Pass end under, then up through the loop. 3. Draw up tight.

Fishermen's bend To tie the fisherman's knot, lay the two ends to be tied alongside each other and facing opposite ways. Tie an overhand knot on the first rope and pass the second rope through the loop formed. Tighten the overhand knot, to prevent the line inside it from flopping around. Then tie another overhand knot on the second rope with the first rope passing through it.

You might also like