Scribd
Upload
92 views3 pages

Eee 226 Microprocessor I Proposal

This project proposes building a microwave system with a 7-segment display, password protection, and an emergency stop feature. The system will display the countdown time on the 7-segment display and stop if the door is opened. It will also require a 4-digit password to start cooking and allow the user 3 attempts to enter the correct password before warning lights activate. The project aims to provide a safe microwave system for cooking.

Uploaded by

楊傑克
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
92 views3 pages

Eee 226 Microprocessor I Proposal

This project proposes building a microwave system with a 7-segment display, password protection, and an emergency stop feature. The system will display the countdown time on the 7-segment display and stop if the door is opened. It will also require a 4-digit password to start cooking and allow the user 3 attempts to enter the correct password before warning lights activate. The project aims to provide a safe microwave system for cooking.

Uploaded by

楊傑克
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd

EEE 226 MICROPROCESSOR I SEMESTER II ACADEMIC SESSION 2013/2014 MINI PROJECT PROPOSAL MICROWAVE SYSTEM (7 SEGMENT)

GROUP: 20 TIME SLOT: FRIDAY (3.00pm-5.00pm)


GROUP MEMBERS: JACKY YONG TUNG KIET TAN CHEE SHENG 117276 117300 MECHATRONIC MECHATRONIC

Pengenalan: This project introduces a microwave system which has the time-counting for the cooking process. The system also has an emergency system that will stop the microwave cooking process when the door of the microwave is opened during the process. This will activate the emergency switch while the LED will blink continuously as a warning of the emergency stop. This is to ensure the safety especially of the kids.

The time counter will operate after the user has pressed the time. One minute counted is the same as the time in reality by controlling and counting the delay time in the system. During the operation, the LED which is connected to PORT B will undergo runnning light. After the 60 seconds have been counted until zero, the minute will decrease by 1.

Besides, there is also passward system installed in the microwave system, where the user is required to enter the password before the microwave can be used. This is also another safety measurements for the kids to prevent them from using it without being supervised by adults since they cannot access to the microwave without the password. Like most of the password system, user can change the password and are given 3 chances to enter the correct password. If the password given is wrong, warning will be given, where the LED will start blinking continuously and non-stop. Situation where the user has forgotten the password is also considered. Therefore, there are 2 passwords prepared for the microwave.

As mentioned above, each user is given 3 chances to enter the 4-digit password to activate the cooking function. However, when the user finds out that the password entered is incorrect after the 1st , 2nd or 3rd digit has been entered, the password can be cleared and the user can reenter the password again. Doing so will prevent the usage of the 3 chances given.

This function also comes to the time insertion process where the user can change the time for the process to allow the user to change the time before the cooking process.

Hope that the microwave system will benefit the people and safe to use for them.

Block Diagram
Two 7-Segment

Series Connection between computer and 8085

Control Bus

8 LED CPU 8085


Address Bus Data Bus

Monitor

8255

You might also like