Scribd
Upload
715 views1 page

Energy Dissipators for Culverts

This chapter discusses four types of streambed level energy dissipators for culvert outlets: the Colorado State University (CSU) rigid boundary basin, Contra Costa basin, Hook basin, and U.S. Bureau of Reclamation (USBR) Type VI impact basin. It provides limitations, design guidance, and examples for each type. The CSU rigid boundary basin uses staggered rows of roughness elements to initiate a hydraulic jump, with the effects of roughness reflected in an empirically derived drag coefficient.

Uploaded by

wilber
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
715 views1 page

Energy Dissipators for Culverts

This chapter discusses four types of streambed level energy dissipators for culvert outlets: the Colorado State University (CSU) rigid boundary basin, Contra Costa basin, Hook basin, and U.S. Bureau of Reclamation (USBR) Type VI impact basin. It provides limitations, design guidance, and examples for each type. The CSU rigid boundary basin uses staggered rows of roughness elements to initiate a hydraulic jump, with the effects of roughness reflected in an empirically derived drag coefficient.

Uploaded by

wilber
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd

Chapter 9 - HEC 14 - Hydraulics - Engineering - FHWA Página 1 de 1

Search FHWA
Go

Scour Technology | Bridge Hydraulics | Culvert Hydraulics | Highway Drainage | Hydrology |


Environmental Hydraulics
FHWA > Engineering > Hydraulics > HEC 14 > Chapter 9
<< Previous Contents Nex

Hydraulic Design of Energy Dissipators for Culverts and Channels


Hydraulic Engineering Circular Number 14, Third Edition
Chapter 9: Streambed Level Dissipators
This chapter contains energy dissipators for culvert outlets that are designed to operate at the streambed
level and reestablish natural flow conditions downstream from the culvert outlet. They are also intended to
drain by gravity when not in operation. The following sections contain limitations, design guidance, and
design examples for the following energy dissipators:
• Colorado State University (CSU) rigid boundary basin
• Contra Costa basin
• Hook basin
• U.S. Bureau of Reclamation (USBR) Type VI impact basin
9.1 CSU Rigid Boundary Basin
The Colorado State University (CSU) rigid boundary basin, illustrated in Figure 9.1, uses staggered rows of
roughness elements to initiate a hydraulic jump (Simons, 1970). CSU tested a number of basins with
different roughness configurations to determine the average drag coefficient over the roughened portion of
the basins. The effects of the roughness elements are reflected in a drag coefficient that was derived
empirically for each roughness configuration. The experimental procedure was to measure depths and
velocities at each end of the control volume illustrated in Figure 9.2, and compute the basin drag coefficient
CB, from the momentum equation by balancing the forces acting on the volume of fluid.
Figure 9.1. CSU Rigid Boundary Basin

[Link] 25/07/2011

You might also like