Scribd
Upload
178 views3 pages

SIDO Buck-Boost PFC Converter Design

This document proposes a single-inductor dual-output buck–boost power factor correction (PFC) converter that can independently regulate each output by multiplexing a single inductor. It offers advantages over conventional two-stage multiple-output converters such as higher efficiency, lower cost, smaller size and lighter weight. The proposed converter is analyzed and suitable for applications like multilevel voltage supply systems and current balancing for multiple LED strings.

Uploaded by

Maruthi Jacs
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
178 views3 pages

SIDO Buck-Boost PFC Converter Design

This document proposes a single-inductor dual-output buck–boost power factor correction (PFC) converter that can independently regulate each output by multiplexing a single inductor. It offers advantages over conventional two-stage multiple-output converters such as higher efficiency, lower cost, smaller size and lighter weight. The proposed converter is analyzed and suitable for applications like multilevel voltage supply systems and current balancing for multiple LED strings.

Uploaded by

Maruthi Jacs
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd

Single-Inductor Dual-Output Buck–Boost

Power Factor Correction Converter

Abstract
Introduction:
A single-inductor dual-output (SIDO) buck– boost power
factor correction (PFC) converter operating in critical
conduction mode is proposed in this paper. By multiplexing a
single inductor, each output of the SIDO buck–boost converter
can be regulated independently. Compared with a conventional
two-stage multiple-output converter, the SIDO buck–boost PFC
converter benefits from significant overall cost saving, small
size, and light weight. Moreover, the efficiency of the SIDO
buck–boost PFC converter can be improved due to single-stage
power conversion.

Existing system:
In order to achieve a high PF and to accurately regulate the
output voltages or currents of a multiple-output ac/dc converter,
a conventional multiple-output ac/dc power converter consisting
of two-stage power conversion is utilized, where the PFC pre-
regulator provides the dc bus voltage vbus and parallel-
connected dc-to-dc regulators are used to regulate the output
voltage or output current from vbus. However, the single-stage
PFC converter can achieve high PF and output current or voltage
regulation at the same time. Hence, it has drawn more and more
attention in recent years.
Proposed system:
In this paper, a novel single-inductor dual-output (SIDO)
buck–boost PFC converter operating in critical conduction mode
(CRM) is proposed. Its control strategy and corresponding
characteristics are analyzed. Independent regulation of each
output can be achieved in this converter by multiplexing a single
inductor.

Advantages:
 High efficiency.
 Cost saving, small size, and light weight.
Applications:
 Multilevel voltage supply systems.
 Current balancing for multiple LED string driving.
 RGB LED lighting.
Block diagram:
Converter 1 Filter 1

Diode
bridge Filter Load 1
rectifier

Converter 2 Filter 2

Single Load 2
phase AC
supply OPTO coupler circuit
12 V
DC

BUFFER
circuit
5 V DC

PIC controller
circuit

Tools and software used:


 MPLAB – microcontroller programming.
 ORCAD – circuit layout.
 MATLAB/Simulink – Simulation.

You might also like