Scribd
Upload
1K views1 page

VW Passat B6 2005 - Steering, Torque Specifications

This document provides torque specifications for fasteners on the steering column and steering gear of a Volkswagen Passat B6 2005. It lists the specific threaded fasteners, their thread size and type, and the required torque in Nm to correctly tighten each one. Proper tightening of fasteners is important for safety and performance of the steering system. Replacement is specified for some fasteners that are removed.

Uploaded by

NP
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
1K views1 page

VW Passat B6 2005 - Steering, Torque Specifications

This document provides torque specifications for fasteners on the steering column and steering gear of a Volkswagen Passat B6 2005. It lists the specific threaded fasteners, their thread size and type, and the required torque in Nm to correctly tighten each one. Proper tightening of fasteners is important for safety and performance of the steering system. Replacement is specified for some fasteners that are removed.

Uploaded by

NP
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd

Volkswagen Passat B6 2005 - Steering, torque specifications Стр.

1 из 1

48 - 3

Steering, torque specifications


Steering column

Threaded fasteners Thread Torque specification (Nm)


To mounting bracket M8 x 30 20
Item - 4 -
Mounting bracket to body M8 x 30 20
Item - 1 - M8 x 85
Frequency damper to mounting bracket M8 x 94 20
Item - 10 -
Frequency damper to body M8 x 48 20
Item - 11 -
Universal joint to steering gear M8 x 35 20 plus an additional 90 1)
Item - 8 -
To handle M6 x 10 3
Item - 7 -
To steering wheel M18 x 1.5 x 18 50

1) Replace each time it is removed

Steering gear

Threaded fasteners Thread Torque specification (Nm)


To subframe 1)
M10 x 70 50 plus an additional 90
Item - 8 -
To shield M6, self-
6
Item - 10 - locking
Tie rod ball joint to wheel Pretighten to 100 Nm, then loosen by 180 and
bearing housing M12 x 1.5
Item - 6 - tighten to 100 Nm again 1)

1) Replace each time it is removed

You might also like