Scribd
Upload
64 views3 pages

At First, I Created A Part Custom Component For Plate Girder Built-Up and Named It As Shown in The Below Snapshot

A user created a custom component for a plate girder but after finishing, two additional custom components with the same name appeared in the window. The user created cuttings and made them into a connection custom component, but is seeing duplicate custom components and is asking for advice on resolving the issue.

Uploaded by

Viet Anh Le
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
64 views3 pages

At First, I Created A Part Custom Component For Plate Girder Built-Up and Named It As Shown in The Below Snapshot

A user created a custom component for a plate girder but after finishing, two additional custom components with the same name appeared in the window. The user created cuttings and made them into a connection custom component, but is seeing duplicate custom components and is asking for advice on resolving the issue.

Uploaded by

Viet Anh Le
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd

At first, I created a part custom component for Plate Girder built-up and named it as shown

in the below snapshot

Then, I created some cuttings and made them as a connection custom component as
shown in the sequences below:
But after I clicked “Finish” there are 2 more additional part custom components having
same names to the first one appearing in the Custom Component Windows

Please help to check and advise.


Thanks!!!

You might also like