Scribd
Upload
2K views1 page

Bus Topology

This document summarizes the setup of a simulation in NS2 to monitor traffic in a bus topology network with 4 nodes connected by a LAN. It creates nodes, attaches agents and applications to generate and receive traffic, connects the traffic sources and sinks, schedules events such as starting/stopping the traffic generation, and runs the simulation for 5 seconds before finishing.

Uploaded by

VenkataramanLakshminarayanan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
2K views1 page

Bus Topology

This document summarizes the setup of a simulation in NS2 to monitor traffic in a bus topology network with 4 nodes connected by a LAN. It creates nodes, attaches agents and applications to generate and receive traffic, connects the traffic sources and sinks, schedules events such as starting/stopping the traffic generation, and runs the simulation for 5 seconds before finishing.

Uploaded by

VenkataramanLakshminarayanan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as TXT, PDF, TXT or read online on Scribd

#***********************************************************************#

#Aim : To monitor traffic for Bus topology using NS2


#***********************************************************************#

#Create a simulator object


set ns [new Simulator]

#Open the nam trace file


set nf [open out.nam w]
$ns namtrace-all $nf

#Define a 'finish' procedure


proc finish {} {
global ns nf
$ns flush-trace
#Close the trace file
close $nf
#Executenam on the trace file
exec nam out.nam &
exit 0
}

#Create four nodes


set n0 [$ns node]
set n1 [$ns node]
set n2 [$ns node]
set n3 [$ns node]
set n4 [$ns node]

#CreateLanbetween the nodes


set lan0 [$ns newLan "$n0 $n1 $n2 $n3 $n4" 0.5Mb 40ms LL Queue/DropTail MAC/Csma/Cd
Channel]

#Create a TCP agent and attach it to node n0


set tcp0 [new Agent/TCP]
$tcp0 set class_ 1
$ns attach-agent $n1 $tcp0
#Create a TCP Sink agent (a traffic sink) for TCP and attach it to node n3
set sink0 [new Agent/TCPSink]
$ns attach-agent $n3 $sink0
#Connect the traffic sources with the traffic sink
$ns connect $tcp0 $sink0

# Create a CBR traffic source and attach it to tcp0


set cbr0 [new Application/Traffic/CBR]
$cbr0 set packetSize_ 500
$cbr0 set interval_ 0.01
$cbr0 attach-agent $tcp0

#Schedule events for the CBR agents


$ns at 0.5 "$cbr0 start"
$ns at 4.5 "$cbr0 stop"

#Call the finish procedure after 5 seconds of simulation time


$ns at 5.0 "finish"

#Run the simulation


$ns run

You might also like