Scribd
Upload
337 views1 page

Denso Tape Technical Data Sheet

The document summarizes the properties and uses of Denso tape, a cold-applied corrosion protection tape. It is a non-hardening, non-cracking tape made of non-woven synthetic fibers coated with petroleum hydrocarbons and siliceous fillers. It is highly resistant to chemicals and impermeable to water and gases. Denso tape is used to protect buried or exposed pipes and fittings from corrosion and has a minimum breaking strength of 200 N/50mm and works in temperatures from -5°C to 55°C.

Uploaded by

BogdanB
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
337 views1 page

Denso Tape Technical Data Sheet

The document summarizes the properties and uses of Denso tape, a cold-applied corrosion protection tape. It is a non-hardening, non-cracking tape made of non-woven synthetic fibers coated with petroleum hydrocarbons and siliceous fillers. It is highly resistant to chemicals and impermeable to water and gases. Denso tape is used to protect buried or exposed pipes and fittings from corrosion and has a minimum breaking strength of 200 N/50mm and works in temperatures from -5°C to 55°C.

Uploaded by

BogdanB
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd

REF: TDS145/01.

01

DENSO TAPE

DESCRIPTION A cold applied tape which remains plastic over a wide temperature range. It is
non-hardening and non-cracking. It is highly resistant to mineral acids, alkalis,
salts and micro-organisms and highly impermeable to water, water vapour and
gases. Used for the protection of buried or exposed pipes, rods, cables,
valves and metal fittings from corrosion.

COMPOSITION Non-woven synthetic fibre fabric impregnated and coated with a neutral
compound based on saturated petroleum hydrocarbons (Petrolatum) and inert
siliceous fillers. It is supplied in rolls in a range of widths.

TYPICAL PROPERTIES TEST METHOD DATA

Breaking Strength ASTM D1000 200 N/50mm minimum

Elongation at Break ASTM D1000 10% average

Breakdown Voltage (55% overlap) 16kV minimum

Resistance to Cathodic Disbonding ASTM G8 – 30 days <500mm²

Resistance to Acids, Alkalis and Salts Excellent

Temperature Range
For Application -5°C to 45°C
For Service maximum 55°C

Roll Length 10 metres minimum

Thickness ASTM D1000 1.15mm average

Weight 1.44 kg/m² average

RECOMMENDED PRIMER Denso Paste, Denso Priming Solution

Important
Winn & Coales (Denso) Ltd pursue a policy to develop and continually improve all of our products and therefore the information
given in this data sheet is intended as a general guide and does not constitute a warranty of specification. However, our sales
personnel are committed to assist the user in establishing the suitability of the product for its intended purpose and additional
specific information is available on request.

Winn & Coales (Denso) Ltd operate a Quality Management System registered to BS EN ISO 9002 1994 (Certificate No. FM01548).

You might also like