Specifications
S No Unit Material Image Specs
1)Immerse the tiles in water for atlease 30-
40 mins, to remove airgap
2)Prepare the
Surface. Make sure your surfaces are clean,
smooth, and dry for best results.
3)Begin Your Layout.
4)Apply the Adhesive.(Cement mortar)Cut GLOSSY KITCHEN TILE,
1 Floor Tile Granite Tile as Needed. RK MARBLES INDIA,
5)Set Your Tile. SIZE: 0.31X0.31X0.02M
6)Grouting Joints.
7)Sealing Grouts(If needed)
1)Cut wood panels to requirements 2)Attach base
panel to side panels using Industrial grade glue or with
screws
3)Add the Top panel to complete the frame of the
cabinet
4)Use sanpaper to remove rough edges as you fix
them
5)Add the back panel once the side outer panels have
been fixed or when the glue has dried
6)Add Half inch thick Plywood on each side for
horizontal Shelves
7)For vertical shelving, add plywood and screw it from
the top and bottom boards 8)After 40 mm thick frame, Dividers
2 Cabinets Plywood the completion of the frame of the cabinets, The 20mm thick, Shelves 20 mm
doors will need to be fixed 9) Door sizes to be thick
cut from Base wood 10) Add Hinge
mechanisms to the inner part of the cabinets, attach it
with screws and then attach the cabinet door
11) Smooth out the entire cabinet
using sandpaper
12)For a painted cabinet, add 2 coats of primer, and
sand it again after drying 13) Add 3-4
thin coats of water based paint
14) If adding a Laminate or Veneer,
Apply the adhesive after first sanding
15) Apply the laminate or veneer and polish it
respectively
1)Cut out a 1/2 inch grout in the wall at the positon of
your coutnertop 2)Using Brick as
support add a Slab which slides into the grout
3)Cut out the sink hole BLACK GALAXY GRANITE,
from the granite RK MARBLES INDIA,
4)Add Cement Mortar on the Slab and place the
3 Countertop Granite Granite SIZE: 0.61X0.61X0.02M
5)Sand paper the edges RS.200/SQ FEET.
6)Add sealant to the cornets and around the edge of
the sink
7) Finish it off with Granite polish.
KAJARIA GLOSS FINISH,
RK MARBLES INDIA,
4 Wall TIle 1 Ceramic Same as floor tiles but on the walls SIZE: .15X.07X0.02M
RS.89/SQ FEET.
GLOSSY KITCHEN TILE,
RK MARBLES INDIA,
5 Wall Tile 2 Ceramic Same as floor tiles but on the walls SIZE: 0.31X0.31X0.02M
RS.80/SQ FEET.
1)Clean the wall with Sandpaper and get rid of any
loose pieces of paint. 2)Add primer LAPPING WAVES - 4284,
Tractor and let it dry for atleast 4 hours NEROLAC PAINTS,
6 Wall Paint 3)Add paint to the walls once its
Emulsion dried up RS.180.
4)Wait for 2-4 hours
1)Cut out the required hole in the granite
2)After the countertop is placed, SINGLE BOWL DRAINER,
place the sink from above and seal off all the CARYSIL VOUGE,
Stainless
7 Sink edges with silicone sealant to stop water SIZE 0.91X0.5M,
steel porosivity 3) Connect the sink to the outlet RS.6039.
Pipe
1)Screw the tap onto the inlet water pipe at HINDWARE,
F100024QT,
Stainless the desired location
8 Faucet CONTESSA SINK TAP,
steel 2)Open the tap to check for any leaks during
RS.951.
installation
BOSCH PBD7351MS,
Connect the burner to and LPG inlet and it is AUTOMATIC SS BURNER,
9 Stove Glass Top SIZE: .75X.45M
ready to use
RS.16299.
1)Screw the main unit to the wall using clamps
2)Screw the tubular FABER CHIMNEY,
outlet pipe to the outlet area on the top of the unit HOOD PRIMUS ENERGY,
Stainless
10 Chimney 3)Connect the Expandable hose to SIZE 0.8X0.48M,
steel the outlet area on the wall. RS.28590.
4)Connect to power
1)Connect the Live and Neutral wire to the
ELECTRICAL SWITCH,
swith receptors on the back ANCHOR MODULAR,
2)Screw the main frame onto the wall
11 Switches Plastic COLOUR : WHITE,
RS.120/PIECE
3)Fix the outer frame on the main frame,
1)Connect the Live and Neutral wire to the SPOTLIGHT,
swith receptors on the back PHILIPS FCG307,
12 Spot Light UPVC 2)Screw the Ligh panel onto the ceiling SIZE 0.09X0.12X0.09M,
RS.2415/PIECE
FLUSH MOUNT,
LEARC,
13 Ceiling Light UPVC Same as spotlight SIZE 0.22X0.22X0.07M,
RS.1189/PIECE
SILVER SS HANDLE,
1)Screw the handle onto the respective 64713-SCH-SS06,
Stainless
14 Cabinet Handle holes of the cabinet COLOUR : 15.24CM,
steel
RS.2076/PIECE
1)Sand the Plywood
SELF ADHESIVE VINYL,
Self 2)Add Adhesive CT 73737. AK,
15 Acrylic Sheet Adhesive SIZE 0.6X3M,
Acrylic 3) Place the sheet on the Plywood RS.1599
without any air bubbles
1)BOTTLE PULL OUT,
HETTICH,
SS, CHROME PLATED
1)Screw on the hardware to the main frame
SIZE 0.20X0.75M
of the Cabinets
Chrome RS.8875
16 Hardware Fittings 2)Then screw on the Door panel or the
Plated 2)CORNER PULL OUT,
Drawer panel
HETTICH,
SIZE 0.50X0.75M
RS.29188
