Optimization Tips for Nokia
System
1: SDCCH Sucess Rate
SDCCH Success Rate Analysis-Nokia System-1
Possible :
•
Interference on BCCH frequency
SDCCH Blocking
SD Drop on Location Update
A_If, TRC or LAPD Fail
HW faulty
Excessive TA
Data Collection :
•
ND Report 72 to check BCCH clearance
Alarm Log
TA distribution ND Report 232
Quality and Link Balance ND Report 195 and 196.
Interference UL and ND 196
SDCCH Success Rate Analysis-Nokia System-2
Problem Analysis :
1. Check possibility Co. or Adj. Interference and clear the BCCH frequency.
2. Check SDCCH utilization and add SDCCH if needed.
3. Change TRP or change SDCCH allocation on TRX with good quality based on ND 196.
4. Check TRX alarm (mostly 7745 together with7743 or 7746). Check TRX configuration.
6. Check TA distribution, coverage distribution and propose physical tune.
3. Optimizing parameter C2 also if Location update is the highest contributor of SD Drop.
4. Highest contributor: Fail on RADIO, ABIS, A_IF, TR or LAPD.
5. Check TRX alarm (mostly 7745 alone or together with 7743)
7. Check RX Lev Access Min and Max Number of Retransmission. Check RACH Rejected and
SDCCH request (fails or ghost).
2: HOSR Analysis
HOSR Analysis-Tips on Nokia system-1
Possibilities :
•
Co or Adjacent BCCH
High TCH Blocking on target cell
Wrong TSC setting regarding BSIC allocation
Bad Neighbor Relation
HW faulty or Unbalance TRX power among a sector
Others ( Inter BSC-Inter MSC)
Preparation Data :
1.
BCCH, BSIC planning, ND report 072
Cell Stat or TQM of HO distribution and ND report 153
Alarm (ZEOH & ZEOL) and site visit
Timing Advance 232
Adjacent Consistency Check ND060, 62 or 69
ND Report 73 to check Undefined Neighbor.
HOSR Analysis-Tips on Nokia system-2
Problem Analysis
1. Check possibility Co. or Adj. Interference then change BCCH frequency.
2. Check neighbor traffic & TCH blocking, check possibility for traffic sharing or directed
retry.
3. TSC value should be same with BCC, check performance HO out and incoming.
4. Parameter setting ADJE to make delay on worst target cell or faster HO on best target,
focused on High HO Fail. Relate parameter FMT or AUCL.
5. Check TRX alarm (mostly 7745 together with 7743 or 7746). Check TRX configuration.
6. Optimize coverage from TA distribution or update missing Neighbor from ND 73.
7. Check the highest handover cause: by interference, quality, level, power budget, GPRS, etc.
Check for the highest HO failure: by Blocked, Conn. Fail., Return to Old, End of HO,etc. The
highest value is possible as the highest contribution of HO fail.
3: TCH Drop Analysis
KPI Analysis on Nokia system-TCH drop-1
Hi All
some guidelines for optimization on Nokia system
The first KPI is TCH drop and Its analysis.
Possibilities :
- Interference on BCCH TRX
- Interference on hopping TRX(DL Interference)
- External Interference (UL interference)
- Bad Neighbor Relation (bad HO)
- Low Coverage
- HW Faulty or TRX Power Unbalance
- Other : A_If, TR or LAPD Fail
Some Important Reports number for Nokia system to analyze the TCH drop:
Preparation Data :
- BCCH Planning, ND report 072 (DL Interference distribution)
- ND Report 216, 196 and Alarm (Interference)
- ND Report 204, 153, 195 ( HO fail and Path Balance)
- ND Report 232 ( Coverage cell)
- ND Report 163 or TQM drop per causes
KPI Analysis on Nokia system-TCH drop-2
Problem Analysis:
1. Check possibility Co. or Adj. Interference. Check clean BCCH frequency.
2. Check DL quality Distribution and Check MAL and MAIO
3. Check UL quality Distribution, check UL interference Pwr Contrl setting to
compensate interference.
4. Check % of HO fail from adjacencies, focused on High HO Fail. Check
TCH_RF_HO_OLD. Check possibility to add some neighbor. Try to prevent un proper HO
and use FMT to reduce drop.
5. Check best serving cell, possibility HO to best serving cell (Macro or Indoor) make it faster
to prevent drop.
6. Check TRX alarm (mostly 7745 together with 7743 or 7746). Check TRX configuration or
reset TRX if needed.
7. Check TA distribution, coverage spillage and proposed physical tune.
8. Check and compare which one the highest: Fail on RADIO, ABIS, A_IF, TR or LAPD.
