Dual Temperature Controller Wiring Guide
Uploaded by
CARLOSDual Temperature Controller Wiring Guide
Uploaded by
CARLOS- DC-20D User Manual Overview
11. WIRING DIAGRAM.
DC-20D Attention:
If you don't use T2 temperature sensor,
cause it is unnecessary in your control
1 2 3 4 5 system, connect the resistor in place of
the T2 sensor (2-3 terminals) and set the
parameter F83=1.
Otherwise the controller will signal the
DC-20D
11 12 13 14 15 16 T1,T2: NTC 5kΩ D1: digital input
OUT1: 20A-AC1 (8A-AC3) 250VAC
sensor failure alarm Alt2. DUAL TEMPERATURE
OUT2: 8A-AC1 (2A-AC3) 250VAC CONTROLLER Version 2.0
OUT1 OUT2 POWER: 230VAC
Make sure that the electrical parameters of the device correspond to the parameters of the
controller (maximum voltage, current rating, power). If the power of receiver is bigger than output USER MANUAL / WARRANTY
load-carrying capacity you should use an additional actuactor: contactor and SSR relay.
Connection diagram of the heating device (for example, boiler, heater) and cooling device
(fan, circulation pump).
Heating device
DC-20D
1 2 3
20(8)A 250VAC
T1
N L
11 12 13 14 15 16
N L L(phase)
230VAC
N (neutral)
Cooling device
T2
N L
11. FACTORY SETTINGS.
If you forgot you password to the configuration menu or the controller after a power failure or a
short circuit displays memory error you can restore default parameter settings:
Turn off the controller. Command disappears
Then press buttons after 5 seconds and four
, at one time and horizontal pointers
set M
switch the power supply display. Then release the
set M
on while holding the buttons and the controller
buttons. Command: restores factory settings
Displays. and goes into normal
operation mode.
