Scribd
Upload
70 views2 pages

Auto Power Supply Control From 4 Different Sources: Solar, Mains, Generator & Inverter To Ensure No Break Power

This project aims to provide an uninterrupted power supply by automatically selecting from four sources: solar, mains, generator, and inverter. It utilizes a microcontroller to detect the failure of any power source and switches to the next available one, with the current source displayed on an LCD. The system can be further enhanced by integrating additional power sources like wind energy to optimize cost efficiency.

Uploaded by

1xBet 1xBet
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
70 views2 pages

Auto Power Supply Control From 4 Different Sources: Solar, Mains, Generator & Inverter To Ensure No Break Power

This project aims to provide an uninterrupted power supply by automatically selecting from four sources: solar, mains, generator, and inverter. It utilizes a microcontroller to detect the failure of any power source and switches to the next available one, with the current source displayed on an LCD. The system can be further enhanced by integrating additional power sources like wind energy to optimize cost efficiency.

Uploaded by

1xBet 1xBet
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd

AUTO POWER SUPPLY CONTROL FROM 4 DIFFERENT

SOURCES: SOLAR, MAINS, GENERATOR & INVERTER


TO ENSURE NO BREAK POWER

ABSTRACT

The main objective of this project is to provide uninterrupted power supply to a


load, by selecting the supply from any source out of 4 such as mains, generator, and
inverter and solar automatically in the absence of any of the source. The demand for
electricity is increasing every day and frequent power cuts is causing many problems in
various areas like industries, hospitals and houses. An alternative arrangement for power
source is a must.

In this project uses four switches to demonstrate the respective failure of that power
supply. When any of the switches is pressed it shows the absence of that particular source,
switches are connected to microcontroller as input signals. A microcontroller of 8051
family is used. The output of microcontroller is given to the relay driver IC, which switches
appropriate relay to maintain uninterrupted supply to the load. The output shall be observed
using a lamp drawing power supply from mains initially. On failure of the mains supply
(which is actuated by pressing the appropriate switch) the load gets supply from the next
available source, say an inverter. If the inverter also fails it switches over to the next
available source and so on. The current status, as to which source supplies the load is also
displayed on an LCD. As it is not feasible to provide all 4 different sources of supply, one
source with alternate switches are provided to get the same function.

The project can be further enhanced by using other sources like wind power also
and then taking into consideration for using the best possible power whose tariff remains
lowest at that moment.
BLOCK DIAGRAM

HARDWARE REQUIREMENTS: SOFTWARE REQUIREMENTS:


8051 series Microcontroller, Relay Driver IC, Keil compiler
Relays, LCD, Lamp, Push Buttons, Transformer,
Diodes, Voltage Regulator, Crystal, LEDS, Languages: Embedded C or Assembly
Capacitors, Resistors.

You might also like