Scribd
Upload
412 views2 pages

Registers: Air Register

The document summarizes the functions of an air register, which is an assembly of components fitted within a boiler casing that divides air flow and directs it to provide the correct air pattern for combustion. The air register divides air into primary and secondary streams, with the primary air flowing to a tip plate to form swirling vortices within the quarl area and the secondary air being rotated by swirler vanes to assist with mixing of air and fuel for shaping the flame. Proper purging of furnaces with air is also summarized as important to prevent explosions from oil vapors and air mixtures within furnace areas.

Uploaded by

Meghanath Adkonkar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
412 views2 pages

Registers: Air Register

The document summarizes the functions of an air register, which is an assembly of components fitted within a boiler casing that divides air flow and directs it to provide the correct air pattern for combustion. The air register divides air into primary and secondary streams, with the primary air flowing to a tip plate to form swirling vortices within the quarl area and the secondary air being rotated by swirler vanes to assist with mixing of air and fuel for shaping the flame. Proper purging of furnaces with air is also summarized as important to prevent explosions from oil vapors and air mixtures within furnace areas.

Uploaded by

Meghanath Adkonkar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd

Registers

AIR REGISTER

This is the name given to an assembly of vane air swirler plates etc fitted
within the boiler casing in association with each burner ,its functions is to
divide air into primary and secondary streams and to direct them such as to
give the correct air flow pattern.

The air must pass through the air check to enter the register . In
some cases the check can be formed by the swirl vanes themselves by rotating
them about their axis, in other cases a sliding sleeve is used.

The inner primary air flows until it reaches the tip plate (stabiliser)
then spills over to form a series of vortices which reduces the forward velocity
of the air. This retains the primary flame within the quarl. The outer, secondary
air passes over the swirler vanes which causes the air to rotate thus assisting
the mixing of air and fuel. The secondary air shapes the flame, short and fat
for side fired, longer and thinner for roof fired. A small amount of cooling air is
allowed to flow to the tip plate and atomiser tip.

It is important that the air check forms a tight seal otherwise


thermal shock can damage the quarls when the burner is not in use. The front
plate is usually insulated , the complexity of the air control is related to the
TDR .The steam jet types have the steam providing additional energy for the
mixture of air and fuel.

- see 'burners' for description of profiled registers

PREPURGING OF FURNACES

Furnace explosions caused by oil vapour and air present in furnace in explosive
proportions. To a lesser extent a blowback is a furnace explosion. Prevention is
by purging with air.

Usually adequate purging is provided within the combustion control


however makers timings should be strictly followed .

N.B. This is particularly important with membrane wall boilers


where the pressure wave is contained within a strong cell which if ruptured,
has disastrous consequences.

You might also like