SAFETY DATA SHEET
SECTION 1—CHEMICAL PRODUCT & COMPANY IDENTIFICATION
Product identifier: AlbaChem® Spot Lifter II
Product Number: 1674 (1674A)
Usage Restriction: In CA, CT, DE, IL, IN, ME, MD, MA, MI, NH, NJ, NY, OH, PA, RI, UT, VA, VT and
DC, this product is for use in manufacturing only. Institutional and consumer uses are prohibited. Check for
compliance with local and state laws.
Date Prepared: July 19, 2017
Revision Date: October 31, 2022
Manufacturer's name and address: Refer to supplier
Supplier name and address:
ALBATROSS USA INC./EXPERT WORLDWIDE
36-41 36th Street 5439 San Fernando Road West
Long Island City, New York Los Angeles, California
United States United States
11106 90039
718-392-6272 818-543-5850
Emergency Telephone #: Spill, leak, fire, exposure or accident – Call CHEMTREC – Day or Night
1-800-434-9300 or 1-703-527-3887 (USA & Canada)
01-800-681-9531 (Mexico)
This MSDS complies with OSHA Hazard Communication Standard 29 CFR 1910.1200
IMPORTANT: Read this MSDS before handling and disposing of this product. Pass this information on to
employees, customers, and users of this product.
SECTION 2 — HAZARDS IDENTIFICATION
GAS UNDER PRESSURE, dissolved
FLAMMABLE AEROSOL, category 1
ASPIRATION HAZARD, category 1
EYE IRRITATION, category 2A
SKIN IRRITATION, category 2
DANGER:
EXTREMELY FLAMMABLE AEROSOL. CONTAINS GAS UNDER PRESSURE; MAY EXPLODE IF HEATED.
MAY BE FATAL IF SWALLOWED AND ENTERS AIRWAYS. CAUSES SKIN AND SERIOUS EYE IRRITATION.
KEEP OUT OF REACH OF CHILDREN.
Keep away from heat, open flames, and hot surfaces. No smoking. Do not spray on an open flame or other ignition source.
Pressurized container: Do not pierce or burn, even after use. Wash hands thoroughly after handling. Wear eye protection and
protective gloves. Specific treatment (see FIRST AID section on this label). Protect from sunlight. Do not expose to
temperatures exceeding 122°F (50°C). Store locked up in a well-ventilated place. Dispose of container in accordance with local
regulations.
IF SWALLOWED: Immediately call a poison control center. Do NOT induce vomiting. IF IN EYES: Rinse cautiously with
water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get
medical advice. IF ON SKIN: Wash with plenty of water. If skin irritation occurs: Get medical advice. Take off contaminated
clothing and wash it before reuse.
AlbaChem Spot Lifter II Page 2 of 4
H.M.I.S® III:
HEALTH *2
FLAMMABILITY 3
PHYSICAL HAZARD 2
SECTION 3 — COMPOSITION/INFORMATION ON INGREDIENTS
Ingredients CAS # % by Weight
Trans-1,2-Dichloroethylene 156-60-5 30-60%
Isopropyl Alcohol 67-63-0 0-10%
Hydrated Amorphous Silica 112926-00-8 < 5%
Liquefied Petroleum Gas 68476-86-8 35-45%
Refer to Section 8 for exposure limits and recommendations.
SECTION 4 — FIRST AID MEASURES
Skin: For skin contact, wash immediately with soap and water. If irritation persists, get medical attention. Eye:
Immediately flush with plenty of water for at least 15 minutes, holding eyelids open at all times. Get medical attention
immediately. Inhalation: Move person to non-contaminated air. If the affected person is not breathing, apply artificial
respiration. Call a physician if symptoms develop or persist. Ingestion: If the material is swallowed, get immediate medical
attention or advice. DO NOT induce vomiting. If vomiting occurs naturally, have victim lean forward to reduce risk of
aspiration. Seek immediate medical attention. Do not give anything.
SECTION 5 — FIRE FIGHTING MEASURES
Extinguishing Media: Use dry chemical, carbon dioxide, or foam. Use water to cool fire-exposed containers and to
protect personnel. Do not direct a solid stream of water or foam into hot, burning pools this may results in frothing
and increase fire intensity. Basic Fire Fighting Procedures: Dangerous when exposed to heat or flame. This
material can be ignited by flame or spark under normal atmospheric condition. Vapors are heavier than air and may
travel along the ground to some distant source of ignition and flash back. Pressurized Container: May explode when
exposed to heat or flame. Empty containers may retain product residue including Flammable or Explosive vapors.
DO NOT cut, drill, grind, or weld near full, partially full, or empty product containers. Dust Explosion Hazard:
None known. Sensitivity To Mechanical Impact: Container could potentially burst or be punctured upon
mechanical impact, releasing flammable vapors. Unusual Fire & Explosion Hazards: During a fire, irritating and
highly toxic gases may be generated during combustion or decomposition. High temperatures can cause sealed
containers to rupture due to a build up of internal pressures. Cool with water. Fire Fighting
Equipment/Instructions: Wear full protective clothing, including helmet, self-contained positive pressure or
pressure demand breathing apparatus, protective clothing and face mask.
Flash Point: concentrate: N/A. propellant: -132.32 F
Flammability limits in air: 23 upper % by volume concentrate 12 lower % by volume concentrate
9.2 upper % by volume propellant 1.8 lower % by volume propellant
SECTION 6 — ACCIDENTAL RELEASE MEASURES
Emergency Action: Evacuate the area promptly and keep upwind of the spilled material. Isolate the spill area to prevent
people from entering. Wear appropriate protective equipment and clothing during clean-up. Containment: Stop discharge if
AlbaChem Spot Lifter II Page 3 of 4
safe to do so. Stop material from contaminating soil or from entering sewers or water streams. Cover spills with non-
flammable absorbent and place in closed chemical waste containers.
SECTION 7 — HANDLING & STORAGE
Handling: Keep this product away from heat, sparks or open flame. Avoid getting this material into contact with our skin
and eyes. Avoid breathing mists or aerosols of this product. Use this product with adequate ventilation. Do not reuse the
empty container. Storage: Store in a cool, dry, well-ventilated area. Do not handle or store near an open flame, heat or other
sources of ignition. Keep out of direct sunlight. Do not store above 120F (49C). Empty Container Precautions: Attention!
Follow label warnings even after container is emptied since empty containers may retain product residues. Do not reuse
empty container.
SECTION 8 — EXPOSURE CONTROLS/PERSONAL PROTECTION
Engineering Controls: Provide local and general exhaust ventilation to effectively remove and prevent buildup of any vapors
or mists generated from the handling of this product. Eye Protection: Wear goggles or safety glasses with side shields. Skin
and Body Protection: Impervious gloves should be used when handling this product. Use of protective coveralls and long
sleeves is recommended. Respiratory Protection: Use NIOSH approved respiratory protection. High airborne
concentrations may necessitate the use of self-contained breathing apparatus (SCBA). General: Use good hygiene practices
in handling this material.
Exposure Limits: (PARTS PER MILLION)
Component(s) TLV OSHA-PEL OSHA-STEL SARA 313 PROP 65 VOC
Trans-1,2-Dichloroethylene 200ppm
Isopropyl Alcohol 200ppm 400ppm 400ppm X
Liquefied Petroleum Gas 1000ppm X
Other raw material is considered trade secret.
SECTION 9 — PHYSICAL & CHEMICAL PROPERTIES
Apperance: Off-white liquid Upper/lower explosive limits: Not available
Odor: Characteristic Vapour pressure: Not available
Odor threshold: Not available Vapour density: Not available
pH: Not available Relative density: Not available
Melting point/freezing point: Not available Solubility: Not available
Initial boiling point and range: Not available Partition coefficient: Not available
Flash point: Not available Auto-ignition temperature: Not available
Evaporation rate: >1 (butyl acetate-1) Decomposition temperature: Not available
Flammability: Flammable gases Viscosity: Not available
Flame extension test: >15 cm; <75cm VOC percentage: 48.6%
SECTION 10 – STABILITY & REACTIVITY
Hazardous polymerization will not occur. Condition to avoid: Keep away from sources of ignition. Avoid contact
with strong oxidizers, reducers, acids, and alkalis. Stability: This product is stable under normal conditions.
AlbaChem Spot Lifter II Page 4 of 4
SECTION 11 – TOXICOLOGICAL INFORMATION
Trans-1,2-Dichloroethylene: Oral LD50: 1,235 mg/kg (rat)
Inhalation LC50: 24,100ppm (mouse)
Dermal LD50: >5,000 mg/kg (rabbit)
SECTION 12 – ECOLOGICAL INFORMATION
No information available.
SECTION 13 – DISPOSAL CONSIDERATIONS
We make no guarantee of warranty of any kind that the use of and/or disposal of this product complies with all local,
state, or federal laws. It is also the obligation of each user of the product mentioned herein to determine and comply
with the requirements of all applicable statutes.
Waste disposal: Dispose of waste material according to Local, State, Federal, and Provincial Environmental
Regulations. Wastes must be tested using methods described in 40 CFR Part 261 to determine if it meets applicable
definitions of hazardous wastes.
SECTION 14 – TRANSPORTATION INFORMATION
Ground Transportation: (Continental United States, Canada & Mexico):
Consumer Commodity ORM-D or Limited Quantity
Ocean: UN 1950 Class 2.1 Flammable Gas, Limited Quantity
Air : We do NOT recommend this product to be shipped via air. It would need to be repacked by an authorized
packing company and the DG would have to be completed by a licensed hazardous material shipping company.
SECTION 15 – REGULATORY INFORMATION
No data available.
SECTION 16 – OTHER INFORMATION
The information in this MATERIAL SAFETY DATA SHEET is pursuant to 29 CFR 1910.1200 to convey
information concerning the hazardous nature of this product. The information supplied was compiled from the most
reliable sources available at the time of preparation and in light of the most reasonable foreseeable exposure situations
expected from the intended use of this product. The material(s) may present greater or lesser hazard under other
circumstances that are beyond the control of the manufacturer. Therefore, it is imperative that all direction and
warnings on the label be read and understood.
Please see Section 1 for appropriate date of preparation.
