Connection:

GASOLINE - GAS switch RPM

regulator in Injection Program
Zetronic
Zetronic
DIGITAL
SWITCH

DIGITAL SWITCH
Installation Guide
To 12 Volts from connector
CODE: ZL-3
FUSE

Coil negative or wind by means

Brown
of 4-5 turns to any spark plug cable
or to the coil one.

To GNV
Green solenoid
Blue To GASOLINE
solenoid
Connect
to ground

Black
White
Violet

W a r r a n t y C o n d i t i o n s

This device has one-yeared warranty

f r o m t h e d a t e o f i t s s a l e .
In order that the warranty is valid, the devices
m u s t n o t h a v e b e e n o p e n e d .
Devices with outer damages will not be accepted.
Zetronic will replace faulty devices but we will not
take responsibility for damages done by its
misfunctioning.
 PT Verónica N. Mailhes
Feature:
This switch is tailored to make the GAS supply reading easier b) NEUTRAL: when the vehicle is on GASOLINE mode and
to the CNG user. The display can be programmed to show in %
the button is pressed, the unit changes to NEUTRAL waiting for
(between 0 and 100%, when full) or in BAR (between 0 and 200
the carburetor box to be empty.
BAR). You can choose GASOLINE or GAS by means of a single
button. This switch can be programmed to carburator or injection c) GAS: pressing the button again, the unit changes to GAS mode.
vehicles.
Operation: Pressing GAS
GASOLINE Pressing NEUTRAL
Switch configured to Injection Vehicles
Pressing
Type of fuel to be used can be chosen with the button.
a) GASOLINE: when the vehicle is on GASOLINE mode,
only this led indicator is on.
b) AUTOMATIC: when the button is pressed, it will change to Programming:
automatic and both leds will be on. After accelerating and Turn the vehicle in contact while pressing the button
passing the RPM to switch to automatic GAS, the unit will and its program will be displayed.
change to GAS remaining only this led indicator on.
To switch back to GASOLINE, press the button.
c) TO GAS DIRECTLY: by pressing the button for 10 seconds
the unit will be on GAS mode direclty without starting on KEEPING THE BUTTON PRESSED,
GASOLINE. Only GAS led is on. THE PROGRAM WILL SWITCH AS FOLLOWS:
GASOLINE Pressing AUTOMATIC
In Injection Program
By keeping pressed for 10 seconds
the unit switches to GAS DIRECTLY
CAR Carburator Program
TO GAS DIRECTLY
Supply reading in %, from 0 to 100%

Button short pressure

dS0 (programmed by factory)
Switch configured to Carburator Vehicles
dS1 Reading in BAR from 0 to 200 BAR
Con el pulsador se selecciona el tipo de combustible a utilizar
a) GASOLINE: when the vehicle is on GASOLINE mode,
only this led indicator is on. fIn Short pressure exits the program