Scribd
Upload
77 views1 page

Quickstart Guid

This document is a quickstart guide for a TIG Brush stainless steel weld cleaning system. It contains instructions for assembly of the unit, safety warnings, and operating instructions. The guide explains how to attach cables and a wand to the unit, select modes of operation, and use the brush to clean welds while keeping it wet. It recommends genuine replacement consumables and provides a hint to only use the tip of the brush for greater efficiency.

Uploaded by

Dinu
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
77 views1 page

Quickstart Guid

This document is a quickstart guide for a TIG Brush stainless steel weld cleaning system. It contains instructions for assembly of the unit, safety warnings, and operating instructions. The guide explains how to attach cables and a wand to the unit, select modes of operation, and use the brush to clean welds while keeping it wet. It recommends genuine replacement consumables and provides a hint to only use the tip of the brush for greater efficiency.

Uploaded by

Dinu
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd

TIG Brush ®

TBE-550
STAINLESS STEEL WELD CLEANING SYSTEM QUICKSTART GUIDE
KIT CONTENTS SAFETY
12 x Brushes Shrouds
& adapters (Up to 3 types)

• INSPECT UNIT FOR DAMAGE


BEFORE EVERY USE.
• EYE PROTECTION AND
GLOVES MUST BE WORN.
• USE ONLY IN A WELL
Red Black Cable Fluids x 2 Power Wand VENTILATED AREA.
TIG Brush Unit Cable and Clamp Cord • KEEP UNIT DRY.
• USE ONLY SINGLE PHASE
AC POWER FROM 110V/240V.
ASSEMBLY • REFER TO FLUID SAFETY
INFORMATION IN SAFETY
• Attach plug on red cable to DATA SHEET.
red connector of TIG Brush
Unit
• Screw wand into handle
• Place shroud on brush and
screw into wand 110V AC 240V AC
• Attach plug on black cable Single phase Single phase
to black connector of TIG
Brush Unit Wand
• Attach clamp to work piece
• Set POWER control to Work piece Shroud
Standby
• Attach power cord to mains
outlet and TIG Brush Unit Brush

INSULATING SHROUD
MUST BE USED!

OPERATION CONSUMABLES

1 Use only genuine


Ensitech consumables:
• Ensure On/Off switch is ON brushes, shrouds and
• Select mode of operation fluids.
• Operate Power Control to select
NARROW or WIDE BRUSH [Link]

STANDBY
POWER

NARROW BRUSH
WIDE BRUSH
RINSE
CLEAN
MODE

RESTORE
SURFACE
MARKING

2
GUIDE- 2015-03-03

HINT 3
G

• Pour recommended cleaning fluid into


GUIDE - DEC-10

suitable container Don’t press hard.


TBE-550 QUICKSTART

• Dip brush For greater • Rinse brush after use to remove


• Brush weld area (see hint) efficiency and solution
QUICKSTART

• Keep brush wet: dry brush is less effective and speed, use tip of • Remove brush (CAUTION: HOT) and
wears out more quickly brush only. rinse thread on brush and wand
BRUSH

• Water rinse work piece to help lower surface


TBE-250

• Retain shroud when disposing of


heat and spray with appropriate neutralising used brush
TIG

fluid, then re-rinse

[Link]

You might also like