HX316C10FW/4
4GB 512M x 64-Bit DDR3-1600
CL10 240-Pin DIMM
SPECIFICATIONS
CL(IDD) 10 cycles
Row Cycle Time (tRCmin) 48.125ns (min.)
Refresh to Active/Refresh 260ns (min.)
Command Time (tRFCmin)
Row Active Time (tRASmin) 37.5ns (min.)
Maximum Operating Power TBD W*
UL Rating 94 V - 0
Operating Temperature 0o C to 85o C
Storage Temperature -55o C to +100o C
*Power will vary depending on the SDRAM used.
DESCRIPTION FEATURES
HyperX HX316C10FW/4 is a 512M x 64-bit (4GB) DDR3-1600 • JEDEC standard 1.5V (1.425V ~1.575V) Power Supply
CL10 SDRAM (Synchronous DRAM) 1Rx8 memory module,
based on eight 512M x 8-bit DDR3 FBGA components. This
• VDDQ = 1.5V (1.425V ~ 1.575V)
module has been tested to run at DDR3-1600 at a low latency • 800MHz fCK for 1600Mb/sec/pin
timing of 10-10-10 at 1.5V. Additional timing parameters are
• 8 independent internal bank
shown in the PnP Timing Parameters section below. The
JEDEC standard electrical and mechanical specifications are • Programmable CAS Latency: 11, 10, 9, 8, 7, 6
as follows: • Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
• 8-bit pre-fetch
Note: The PnP feature offers a range of speed and timing options to support
the widest variety of processors and chipsets. Your maximum speed will • Burst Length: 8 (Interleave without any limit, sequential with
be determined by your BIOS. starting address “000” only), 4 with tCCD = 4 which does not
allow seamless read or write [either on the fly using A12 or
MRS]
PnP JEDEC TIMING PARAMETERS:
• Bi-directional Differential Data Strobe
• DDR3-1600 CL10-10-10 @1.5V
• DDR3-1333 CL9-9-9 @1.5V
• Internal(self) calibration : Internal self calibration through ZQ
pin (RZQ : 240 ohm ± 1%)
• DDR3-1066 CL7-7-7 @1.5V
• On Die Termination using ODT pin
• Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE < 95°C
• Asynchronous Reset
• Height 1.291” (32.80mm) w/heatsink, single sided
component
Continued >>
[Link]/hyperx Document No. 4807016-001.B00 04/23/15 Page 1
continued HyperX
MODULE WITH HEAT SPREADER
7.08 mm
133.35 mm
32.8 mm
MODULE DIMENSIONS
FOR MORE INFORMATION, GO TO [Link]/HYPERX
All Kingston products are tested to meet our published specifications. Some motherboards or system configurations may not operate at
the published HyperX memory speeds and timing settings. Kingston does not recommend that any user attempt to run their computers
faster than the published speed. Overclocking or modifying your system timing may result in damage to computer components.
[Link]/hyperx Document No. 4807016-001.B00 Page 2
