Scribd
Upload
156 views1 page

Job Safety Analysis for Greasing Crown

The document outlines safety procedures for greasing a crown on a drilling rig. It lists 10 steps of the work sequence and associated hazards. Recommendations are provided to eliminate or reduce hazards. Required protective equipment is listed. The JSA must be approved and signed off before work.

Uploaded by

aHMED
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
156 views1 page

Job Safety Analysis for Greasing Crown

The document outlines safety procedures for greasing a crown on a drilling rig. It lists 10 steps of the work sequence and associated hazards. Recommendations are provided to eliminate or reduce hazards. Required protective equipment is listed. The JSA must be approved and signed off before work.

Uploaded by

aHMED
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd

Job Safety Analysis (JSA )

HOIST No. 21 Main Job: Greasing Crown Register No: 12


Location : BLOCKS 60 & 48 Work Area: Hoist Last Review date: 17/06/21

Work Sequence (Job Hazards or Potential Recommendations to Eliminate


[Link] Responsibility
Steps) Incidents or Reduce Hazards
1. Raise Work Permit Slip, Falls, Trip Never rush and pay attention Rig Manager /Tool Pusher
/Driller
2. Inspect Fall Protection and Damaged belt and lanyard and Inspect Fall protection and equipment Rig Manager /Tool Pusher
Grease Gun grease gun prior to use /Driller
3 Use Tethered Grease Gun or Ripped Tethered strap, cut safety Use tethered grease gun or with 100% Rig Manager /Tool Pusher
attach safety cable to grease cable tie off /Driller
gun
4 Use proper PPE and all loose Caught by loose clothing on Always use proper PPE and loose Rig Manager /Tool Pusher
clothing tucked in and button equipment clothing tucked in and button up /Driller
up
5 Register over head hazard Forgetting tools at height, Proper communication and always Rig Manager /Tool Pusher
tools and inform driller prior to miscommunication register over head tools /Driller
climb to crown
6 Use hand over hand while Slips, Falls, Struck by Use hand over hand grip and do not Rig Manager /Tool Pusher
climbing derrick ladder rush in climbing to mast /Driller
7 Before unlatching climb assist Falls, Pinched By Use 100% tie off technique, Always tie Rig Manager /Tool Pusher
tie off lanyard then unhooked off before unlatching yourself /Driller
yourself
8 Grease Crown and Inspect Slips, Falls, Caught by, Smashed While greasing do not drop excessive Rig Manager /Tool Pusher
Sheaves Limbs grease and don’t get caught in moving /Driller
sheaves
9 Climb down never slide down Falls, Slips, Struck by Never slide down mast ladder and use Rig Manager /Tool Pusher
and inform the driller hand under hand grip /Driller
10 Sign In tools and put in a Leaving tools at crown, Falling Sign In at register tools at height, Close Rig Manager /Tool Pusher
proper place objects Work Permit /Driller
List Below the Protective Equipment, Special Tools Other Safety Equipment Required to do this Job
Safety glass, hand gloves, Safety Harness Grease Gun 100% tie off.

SIGN-OFF

JSA Written By: JSA Approved By:

Job Title: Asst. Driller Job Title: TOOL PUSHER

Control document FORM # 16.06.21/01

You might also like