10 Watt Audio Amplifier Circuit
Simple 10 Watt Audio Amplifier Circuit designed by using IC
LM1875, it can drive 8Ω speaker and gives 10 Watt output.
Lower power audio output required systems can use this 10
watt audio amplifier circuit, it requires few external
components and low space circuit construction.
LM1875 is monolithic power amplifier offering very low
distortion, this IC can deliver upto 30 watts when we use 30V
bias. It has thermal protection and internal output protection
diodes. It comes in TO-220 package.
Circuit diagram
Components Required
1. Audio amplifier IC LM1875
2. Loud Speaker 8Ω
3. Resistor 82KΩ = 2
4. Resistor 4.3KΩ, 10Ω each one
5. Capacitor 4.7µ, 1000µF, 0.1µF each one
Construction & Working
IC LM1875 has only five pins, here two are input terminals,
one is output terminal and remaining two for bias. Here audio
input signal is applied to the Non inverting input terminal
Inverting input terminal is connected between feedback
Resistor R3 and to ground supply through R2, C1 elements.
IC LM1875 Pin details
In this audio amplifier circuit we except 10 Watts audio
output only hence we have connected 8Ω loud speaker at
output and applied +9V as a bias supply. Amplified audio
output is fed into speaker through C3 capacitor.
The IC LM1875 provides low distortion level even at the high
output power levels. It also has high gain and fast slew rate.
This IC provides large output voltage swing so that speaker
can respond well for output audio signal. This Amplifier
provides internally compensated and stable operation for
gain of 10 or greater.
