Non-Destructive Testing in Metal AM
Uploaded by
Meiyazhagan RajasekaranNon-Destructive Testing in Metal AM
Uploaded by
Meiyazhagan RajasekaranMETAL ADDITIVE MANUFACTURING
Assignment 10
1. Which of the following is not a Non-destructive test?
a) Tensile strength test
b) Rockwell hardness test
c) Compression test
d) All of these
2. Ultrasonic NDT technique is used for the detection of internal and surface defects in ______
materials.
a) sound conductive
b) sound insulator
c) sound proof
d) None of these
3. Magnetic testing is restricted to _______ materials?
a) diamagnetic
b) paramagnetic
c) ferromagnetic
d) None of these
4. Find the correct sequence of penetrant test.
i. Apply developer
ii. Penetrant applied to the surface
iii. Surface preparation
iv. Surface inspection
v. Excess surface penetrant removed from the surface
a) v, i, ii, iii, iv
b) iii, ii, v, i, iv
c) iv, i, ii, v, iii
d) i, iii, iv, ii, v
5. The source of radiation can be either an X-ray tube or a radioactive isotope.
a) True
b) False
6. Visual testing is normally applied with the use of any additional equipment.
a) True
b) False
7. X-Ray computed tomography is______ compared to Magnetic Resonance Imaging (MRI) scan.
a) cheaper
b) quicker
c) superior
d) All of these
8. CT scans are ______ concerned with motion artifacts than Magnetic Resonance Imaging (MRI)
scans.
a) less
b) more
c) equally
d) None of these
9. Upon completion of the Non-Destructive testing, the component ________used.
a) can’t be
b) can still be
c) Both of these
d) None of these
10. Frequency range for Ultrasonic Non-Destructive Testing is usually about 1 MHz to 6 MHz.
a) True
b) False
