MAS LINOL ART
General Description: Surface Preparation:
MAS LINOL ART is a water based and New Concrete:
transpiring decorative paint with particular and Surface must be clean, structurally
beautiful satined, antique and classic effect. sound, and free from all contaminants
Easy application and wide range of colours including curing compounds, form
helps to redecorate houses, villas, shops, flats release agent, dust, dirt, oil, old coatings
into sophisticated and exceptional scenery of and paint.
renaissance palaces. This product is created to New concrete and masonry surfaces
give new decorative solutions for interiors in should be cured for at least 28 days.
order to make your environment unique for their Provide an absorptive surface on all
refine elegance. substrates including smooth precast or
Major Uses: formed concrete.
Best applied for interior and exterior masonry The moisture content of the concrete
walls, gypsum, concrete and mineral surfaces should be below 4% by weight.
General Characteristics and Physical All laitance must be removed prior to the
Properties: next step in surface preparation.
Remove form marks and other
Appearance As per catalogue protrusions.
Specific Weight 1.00 kg. / lit. Ensure that the surface is fully dry prior
Dilution Ready to use (you can to the application of corresponding
add 5% if needed) primer and subsequent coating.
Coverage 5 - 6 m2/liter Old Concrete:
VOC 45 G/L Old concrete should be clean and in
Drying Time 3 - 4 hrs. at 200C good state . Cracks, holes and other
Application irregularities should be filled in.
50C - 300C All blistered, cracks and peeled-off paints
temperature
Resistance Good resistance for should be removed either by grit
abrasion once hardened blasting, mechanical sanding or paint
Washability Good after hardened stripper.
using water and normal Penetrated paint must be cleaned and
detergent treated with ammonia solution.
Stability Approximately one (1 ) Glossy finish coat must be sanded.
year min. into the Oils and greases are best removed by
packaging. steam cleaning in conjunction with a
detergent solution. Thorough scrubbing
with hot caustic solutions will also
remove mineral oils and greases
The above information is given to the best of our knowledge based on laboratory test and practical experience. However, as the paint is often used under
condition beyond our control, we cannot guarantee anything but the quality of the paint itself. We reserve the right to change the given data without prior notice.
MAS PAINTS & CHEMICAL INDUSTRY
P.O. BOX NO: 23085, SAJJAH INDUSTRIAL AREA, SHARJAH, U.A.E
TEL NO: 009716 5311777; FAX: 009716 5311330
Website : [Link]
Email : masuae@[Link]
Old Wood, Old Iron: for about 15-20 cm. long in all directions
Previously painted with alkyds and P.U. with small amount of pressure to achieve
paints. a crushed and small particles thus
Remove grease from the surface and creating a classical chromatic effect.
sand well. Brush + Spatula
Smoothen with 280 – 300 grit sand This classic effect can also be achieved
paper to facilitate the adhesion of by applying MAS LINOL ART with a
subsequent primer. suitable brush in all directions for about
New Iron: 8-12 cm. long, moving from right to left
Smoothen the surface with sandpaper. and vice versa, and from bottom to top
Remove traces of oil, grease and other and vice versa, leaving a thin layer of the
contaminants and apply one (1) coat of product, which is more or less uneven.
Standard Deruster. Let it dry for 20 minutes, smoothen the
Apply one (1) coat of anti corrosive coated surface with stainless steel
primer to protect the surface from rust. trowel, moving in all directions. After 5-6
Application Procedure: hours, apply the second coat of MAS
Please ensure that the surface is properly LINOL ART with the brush, with the
prepared with the application of MAS Masonry same method as the first coat.
AR Primer as an impregnating sealer to protect Note: When the product is applied for outdoors,
the concrete from efflorescence, MAS PVA please ensure that the coating is fully dry prior to
Wall Filler (if necessary to even up surface the application MAS Protect as a protective
irregularities.) and Mascryl (as specified) as an coating.
intermediate coat prior to the application of Packaging:
MAS LINOL ART. It is imperative to ensure that Normally 4 kg, and 20 kg in plastic bucket are
the surface to be coated should be free from available upon request.
other contaminants, oil, grease and concrete Colours Availability:
laitance. - MAS LINOL ART
Classic Effect: - Toner Pearl
Spatula - Premeasured colorant to get required colours.
Ensure that the surface is fully dry, Physiological Hazards:
clean and free from any contaminants. MAS LINOL ART is water-based paint,
Apply Mascryl (specified colour) using nevertheless, good ventilation in working rooms
the special brush and keep it dry. is recommended as well as the use of safety
Apply MAS LINOL ART with stainless tools and equipment. MAS LINOL ART is
steel trowel, using uneven stroke harmful if swallowed. If contact with eyes or skin
between 15 – 30 cm. long in all occurs, wash well with fresh water and seek
directions, leaving a thin and irregular immediate medical advice.
layer of the product on the surface. After
5-6 hours, apply the second coat, using
the same method as for the first coat.
Wait for approximately 1 hour and
smoothen the coated surface with the
same trowel horizontally and vertically
The above information is given to the best of our knowledge based on laboratory test and practical experience. However, as the paint is often used under
condition beyond our control, we cannot guarantee anything but the quality of the paint itself. We reserve the right to change the given data without prior notice.
MAS PAINTS & CHEMICAL INDUSTRY
P.O. BOX NO: 23085, SAJJAH INDUSTRIAL AREA, SHARJAH, U.A.E
TEL NO: 009716 5311777; FAX: 009716 5311330
Website : [Link]
Email : masuae@[Link]
