Doc No: BENZENE
Attest Inspection, LLC Initial Issue Date 02/08/2010
Safety Management System
Revision Date: Initial Version
Revision No. 0
BENZENE and BENZENE AWARENESS PROGRAM Next Revision Date: As Needed
Page 1 of 5
Preparation: Safety Mgr Authority: President Issuing Dept: Safety Page: - 1 -
Page 1 of 5
Purpose
The purpose of this program is to define work practices, administrative procedures and engineering controls to
protect employees exposed to benzene concentrations above the OSHA action level. This plan shall be
implemented and kept current by the Safety Manager as required to reflect the most recent exposure monitoring
data.
Scope
This program covers all employees who may be exposed to benzene in the course of completing job duties. This
written plan shall be made available to the Assistant Secretary, the Director, affected employees and designated
employee representatives. When work is performed on a non-owned or operated site, the operator’s program
shall take precedence, however, this document covers Attest Inspection, LLC employees and contractors and shall
be used on owned premises, or when an operator’s program doesn’t exist or is less stringent. Employees will be
aware of provisions of site specific contingency/emergency plans by either Attest Inspection, LLC or of a facility
owner.
The Attest Inspection, LLC Safety Manager will develop and implement project/task specific benzene control
procedures prior to the start of activities that may include exposure to benzene. Attest Inspection, LLC will be
aware of an owner’s contingency plan provisions and all employees must be informed where benzene is used in
host facility and aware of additional plant safety rules.
Employees may be exposed to benzene in petroleum refining sites, tank gauging (tanks at producing, pipeline &
refining operations) and field maintenance operations.
Definitions
Action Level – means an airborne concentration of benzene of 0.5 ppm calculated as an 8-hour time-
weighted average.
Benzene – a toxic, colorless liquid or gaseous material. Benzene has an aromatic odor, is not soluble in
water and is flammable.
Employee exposure – exposure to airborne benzene that would occur if the employee were not using
respiratory protective equipment.
Health Effects – Short-term exposure causes depression of the central nervous system (CNS), marked by
drowsiness, dizziness, being irritable, being euphoric, headache, nausea, loss of coordination, confusion
and unconsciousness. No effects are expected at 25 ppm. Exposure to 50 to 150 ppm produces headache,
and tiredness. Eye and skin irritation, nose and throat irritation have also been reported following short
term exposure.
Uncontrolled copy if printed.
Printed on: 21 January 2025 12:51 PM © Attest Inspection, LLC 2010
Valid on day of printing only.
Doc No: BENZENE
Attest Inspection, LLC Initial Issue Date 02/08/2010
Safety Management System
Revision Date: Initial Version
Revision No. 0
BENZENE and BENZENE AWARENESS PROGRAM Next Revision Date: As Needed
Page 2 of 5
Preparation: Safety Mgr Authority: President Issuing Dept: Safety Page: - 2 -
Page 2 of 5
Key Responsibilities
Manager or Designee
Ensure personnel are aware of work that has the potential of exposure to benzene.
Ensure individuals responsible for monitoring areas of exposure are properly trained.
Ensure personnel receive documented medical surveillance exams.
Ensure that emergency exams are performed if an overexposure or suspected overexposure occurs.
Supervisors
Ensure employees have the appropriate personal protective equipment (PPE) and are properly trained in
its use and care.
Ensure employees comply with the benzene control program.
Safety Manager
In coordination with the Manager, develop and implement project/task specific benzene control
procedures prior to the start of activities that may include exposure to benzene.
Coordinate monitoring activities, ensuring monitoring equipment is in proper working order and, as
necessary, modifying the benzene control procedures to reflect exposure monitoring data.
Maintain the benzene control program, notify management of any regulatory changes and ensure
compliance with regulatory, client and corporate requirements.
Coordinate training activities.
Coordinate the medical surveillance program, including maintenance of medical records and
administration of exams.
Ensure, that due to the flammability of benzene, fire extinguishers shall always be readily available
Employees
Comply with the benzene control program.
Know where benzene is used at Attest Inspection, LLC or client facilities and follow any of additional plant
safety rules required by the client.
Comply with the medical surveillance program and attend examinations as required.
Maintain respiratory protection equipment in good working order and notify the supervisor or Safety
Representative of any problems prior to starting work
Review material safety data sheets or consult with the supervisor to identify any container with benzene
containing material.
Not smoke in prohibited areas where benzene is present.
Report exposures resulting in any symptoms immediately.
Uncontrolled copy if printed.
Printed on: 21 January 2025 12:51 PM © Attest Inspection, LLC 2010
Valid on day of printing only.
Doc No: BENZENE
Attest Inspection, LLC Initial Issue Date 02/08/2010
Safety Management System
Revision Date: Initial Version
Revision No. 0
BENZENE and BENZENE AWARENESS PROGRAM Next Revision Date: As Needed
Page 3 of 5
Preparation: Safety Mgr Authority: President Issuing Dept: Safety Page: - 3 -
Page 3 of 5
Procedure
Permissible Exposure Limits
The time-weighted average limit (TWA) for benzene is:
8-hour TWA 1 ppm
12-hour TWA 0.67 ppm
The short-term exposure limit (STEL) for benzene is 5 ppm.
Regulated Areas
Attest Inspection, LLC shall establish regulated areas wherever airborne concentration of benzene exceeds
or can reasonably be expected to exceed the PEL or STEL.
Attest Inspection, LLC will control access to regulated areas and limit access to authorized personnel.
The following signage shall be posted in all regulated areas when the potential exists for benzene vapors to
be in excess of the PEL:
DANGER – BENZENE REGULATED AREA CANCER CAUSING AGENT FLAMMABLE – NO SMOKING AUTHORIZED
PERSONNEL ONLY RESPRIATOR REQUIRED
Methods of Compliance
The benzene control program shall be written and implemented to comply with OSHA regulation 29 CFR
1910.1028 (Benzene).
Attest Inspection, LLC shall establish and implement a written program to reduce employee exposure to or
below the PEL primarily by means of engineering and work practice controls to ensure compliance with the
benzene control program and federal and state requirements.
Exposure Monitoring
Exposure monitoring shall be performed for the 8-hour and 12-hour TWAs or for the 15 minute STEL exposure
when:
Regulated areas are established
An emergency occurs that could require a regulated area
A change in the production, process, control equipment, personnel or work practices may result in new or
additional exposure to benzene
Cleanup of a spill, leak repair, or rupture occurs
If the monitoring required reveals employee exposure at or above the action level but at or below the
TWA, Attest Inspection, LLC shall repeat the monitoring for each employee at least every year.
If the initial monitoring reveals employee exposure to be below the action level Attest Inspection, LLC may
discontinue the monitoring.
Uncontrolled copy if printed.
Printed on: 21 January 2025 12:51 PM © Attest Inspection, LLC 2010
Valid on day of printing only.
Doc No: BENZENE
Attest Inspection, LLC Initial Issue Date 02/08/2010
Safety Management System
Revision Date: Initial Version
Revision No. 0
BENZENE and BENZENE AWARENESS PROGRAM Next Revision Date: As Needed
Page 4 of 5
Preparation: Safety Mgr Authority: President Issuing Dept: Safety Page: - 4 -
Page 4 of 5
If the monitoring reveals that employee exposures, as indicated by at least two consecutive measurements
taken at least 7 days apart, are below the action level Attest Inspection, LLC may discontinue to monitor.
Direct reading detection instruments (Drager CMS is recommended) will be used where benzene vapors
may be present in work areas not previously monitored.
Personal monitoring will be performed by use of vapor monitoring badges following manufacturer
requirements. All samples shall be analyzed at an AIHA (American Industrial Hygiene Association) certified
laboratory.
Medical Surveillance
Baseline and annual medical exams shall be provided to employees that may work or are anticipated to
participate in operations more than 10 times per year or may work in areas where benzene exposures may
exceed the PEL over 30 days per year.
Attest Inspection, LLC shall make available a medical surveillance program for employees who are or may
be exposed to benzene at or above the action level 30 or more days per year; for employees who are or
may be exposed to benzene at or above the PELs 10 or more days per year; for employees who have been
exposed to more than 10 ppm of benzene for 30 or more days in a year prior to the effective date of the
standard when employed by their current employer.
Notification of monitoring results shall be provided to employees in writing within 15 working days of
receipt of results.
Personal Protective Equipment
PPE will be selected on the basis of its ability to prevent absorption, inhalation and ingestion.
PPE will reflect the needs of the employee based on work conditions, amount and duration of exposure
and other known environmental factors but shall contain as a minimum; boots, proper eye protection,
gloves, sleeves, aprons and others as determined.
PPE shall be provided and worn when appropriate to prevent eye contact and limit dermal exposure to
liquid benzene. PPE must meet the requirements of 29 CFR 1910.133 and provided at no cost to the
employees.
Respiratory Protection
A respiratory protection program shall be established in accordance with 29 CFR 1910.134. Respiratory
protection is required:
o During the time period necessary to implement engineering controls or work practices.
o When engineering and work practices are not feasible.
o In emergencies.
Approved respirators shall be selected according to airborne concentrations of benzene or condition of use.
0 to 0.67 ppm – no respirator required
0.67 to 6.7 ppm – half-mask respirator with OV cartridges
Uncontrolled copy if printed.
Printed on: 21 January 2025 12:51 PM © Attest Inspection, LLC 2010
Valid on day of printing only.
Doc No: BENZENE
Attest Inspection, LLC Initial Issue Date 02/08/2010
Safety Management System
Revision Date: Initial Version
Revision No. 0
BENZENE and BENZENE AWARENESS PROGRAM Next Revision Date: As Needed
Page 5 of 5
Preparation: Safety Mgr Authority: President Issuing Dept: Safety Page: - 5 -
Page 5 of 5
6.7 to 33 ppm – full-face respirator with OV cartridges
Greater than 33 ppm – Due to the Attest Inspection, LLC policy of not permitting SCBA no employee shall
enter a space containing more than 33 ppm.
Recordkeeping
Medical surveillance records shall be maintained for 30 years after termination of employment
Exposure monitoring records shall be maintained for 30 years after completion of the project
Exposure and medical monitoring records shall be made available to affected employees or their
representatives and to OSHA upon request
Communication of Benzene Hazards
Signs and labels shall be posted at entrances of regulated areas
The benzene control program shall be updated by the Attest Inspection, LLC Safety Manager
Project site specific contingency and emergency procedures shall be updated by the Safety Manager and
made available to project staff prior to beginning work at the specific site.
Uncontrolled copy if printed.
Printed on: 21 January 2025 12:51 PM © Attest Inspection, LLC 2010
Valid on day of printing only.
