Single Aisle
TECHNICAL TRAINING MANUAL
M35 LINE MECHANICS (CFM 56) (Lvl 2&3)
GENERAL
This document must be used for training purposes only
Under no circumstances should this document be used as a reference
It will not be updated.
All rights reserved
No part of this manual may be reproduced in any form,
by photostat, microfilm, retrieval system, or any other means,
without the prior written permission of AIRBUS S.A.S.
AIRBUS Environmental Recommendation
Please consider your environmental responsability before printing this document.
Single Aisle TECHNICAL TRAINING MANUAL
GENERAL
Maintenance External Visit (2) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
UCC11021 - U2935T0
M35 LINE MECHANICS (CFM 56) (Lvl 2&3) TABLE OF CONTENTS Feb 01, 2011
GENERAL Page 1
Single Aisle TECHNICAL TRAINING MANUAL
MAINTENANCE EXTERNAL VISIT (2)
EXTERNAL VISIT
The exterior inspection is done to make sure that the overall condition
of the aircraft and the components and equipment that can be seen are
safe for the flight.
NOTE: Note: The instructions for the checks that must be done are in
the FCOM.
The maintenance personnel usually does a full inspection before each
originating flight. If no maintenance personnel is available, a flight crew
member does the full inspection. The parking brake must be on during
the exterior inspection to let the flight crew do a check of the brake wear
indicators.
Do a check of the structure for impact damage.
Do a check for signs of fuel, oil or hydraulic leaks.
WARNING: If a landing gear door is open, contact the maintenance crew
before you apply hydraulic power.
UCC11021 - U2935T0 - UM01D4000000001
M35 LINE MECHANICS (CFM 56) (Lvl 2&3) MAINTENANCE EXTERNAL VISIT (2) Feb 01, 2011
GENERAL Page 2
Single Aisle TECHNICAL TRAINING MANUAL
UCC11021 - U2935T0 - UM01D4000000001
EXTERNAL VISIT
M35 LINE MECHANICS (CFM 56) (Lvl 2&3) MAINTENANCE EXTERNAL VISIT (2) Feb 01, 2011
GENERAL Page 3
AIRBUS S.A.S.
31707 BLAGNAC cedex, FRANCE
STM
REFERENCE UCC11021
FEBRUARY 2011
PRINTED IN FRANCE
AIRBUS S.A.S. 2011
ALL RIGHTS RESERVED
AN EADS COMPANY
