Scribd
Upload
43 views1 page

Mixer Machine Fabrication Guide

Chapter four outlines the procedure for fabricating a mixer machine, detailing the cutting of metal components and assembly steps. Key tasks include cutting angle bars and stainless steel sheets, welding parts, and assembling the paddles and gearbox. The chapter emphasizes the importance of securing all components properly for functionality.

Uploaded by

labemanza03
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
43 views1 page

Mixer Machine Fabrication Guide

Chapter four outlines the procedure for fabricating a mixer machine, detailing the cutting of metal components and assembly steps. Key tasks include cutting angle bars and stainless steel sheets, welding parts, and assembling the paddles and gearbox. The chapter emphasizes the importance of securing all components properly for functionality.

Uploaded by

labemanza03
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd

Chapter four

Procedure in fabricating the machine

1. Cut the 1”x1”x20” angle bar into different sizes required in making the frame of the mixer
bucket: a) cut four pieces eleven inches long, use as a brace of mixer b) cut two pieces 20
inches long, use as bucket frame.
2. Divide the stainless plain sheet into three: 1 piece 20 inches by 52 inches, use as bucket; 2
pieces 12 by 20 for the left and right siding.
3. Cut into eight the 24 inches by .25mm stainless steel, use as paddle bucket.
4. Weld the parts being used for the mixer’s frame.
5. Put inside the frame the 20 by 52 inches stainless steel to form bucket.
6. Attached the right side siding to connect the right pillow block bearing with 8 inches upper
part centered to the bucket.
7. Assemble the 4 paddles connected to the 24” main shaft.
8. Put the 22 pieces 3/16 machine bolt and knot to lock the right side siding.
9. Lock the pillow block on the right, Lock the pillow block on the left side.
10. Attached the 36 teeth sprocket to the main driving shaft and lock.
11. Attached the chain for transmission to the gearbox.
12. Weld the basement of the gearbox.
13. Weld the basement of the driving electric motor.
14. Lock the gearbox on its basement.

You might also like