Subaru Outback 2020
INSTALLATION FILE
The CAN wiring is located in the speedometer wiring harness. Remove the speedometer assembly to
HIGHBEAM access.
HIGHBEAM3
Red = CAN HI
HIGHBEAM3R
Black = CAN LO
Please ensure that you connect the product to the vehicle CAN Bus wires detailed above.
CANNECT Wire Product Wire Connection Point Or Output Function
RED > Connect via a 5A fuse to a PERMANENT 12v supply.
BLACK > Connect to a good chassis GROUND point.
WHITE > CAN HI Connection : Vehicle CAN HI wire.
BLUE > CAN LO Connection : Vehicle CAN LO wire.
HIGHBEAM3 Side Lights Output : 12v (1A max) when the side lights are active.
GREEN
HIGHBEAM3R High Beam Output : 12v (1A max) when the high beam is active.
HIGHBEAM High Beam Output : 12v (1A max) when the high beam is active.
PURPLE HIGHBEAM3
Ignition On Output : 12v (1A max) when the ignition is switched on.
HIGHBEAM3R
HIGHBEAM3 High Beam Output : 12v (1A max) when the high beam is active.
BROWN
HIGHBEAM3R Reverse Output : 12v (1A max) when reverse gear is selected.
Some outputs may be unavailable due to the specification of the subject vehicle. The output wires listed above may not be featured on all interfaces.
Wiring details correspond to our standard range of interfaces. For bespoke software, please refer to the specific instructions provided with your unit.
Installation Testing
Connect the interface to the plugin wiring harness and turn the vehicle's ignition 'on'
The CANNECT interface switches on automatically when CAN activity is detected. The interface has an LED status indicator next to
the connection plug, which will illuminate GREEN when valid CAN data has been identified by the interface. When the vehicle is moving,
the GREEN LED will flash to indicate that CAN Bus speed information is being processed.
If the LED indicator is illuminated RED for more than 10 seconds, the interface is functioning but cannot identify the vehicle. It is very
important that the interface is only connected to the vehicle CAN Bus wiring at the connection point location detailed at the top of the
page. If the LED remains solid RED, please disconnect and reconnect the unit from the harness with the ignition on.
If the LED fails to illuminate or flash, there is a power connection problem recheck the connections. If the LED flashes RED
continuously, the interface is powered but is not reading CAN data. Check the interface CAN HI and CAN LO connections are the
correct way around. Also check that these wires are connected to the CAN Bus wires as detailed above.
The CANNECT interface automatically switches off when the vehicle CAN Bus is inactive. This can be tested by removing the keys
from the ignition, closing all vehicle doors and switching all auxilliary equipment 'off'. The interface LED should extinguish within 60
seconds.
Subaru Outback 2020
INSTALLATION IMAGES
Subaru Outback 2020
INSTALLATION IMAGES
Subaru Outback 2020 Interior Example
CAN Wiring
