Scribd
Upload
128 views1 page

Gabbiani Galaxy T3 Maintenance Checklist

The Gabbiani Galaxy T3 periodic maintenance checklist outlines daily, weekly, monthly, and annual tasks required for machine upkeep, including cleaning, lubrication, inspections, and replacements. Key tasks include verifying blade sharpness, checking alignment, and inspecting safety devices. Standard notes emphasize safety protocols and the use of approved parts and maintenance logging.

Uploaded by

Hayat Hyt
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
128 views1 page

Gabbiani Galaxy T3 Maintenance Checklist

The Gabbiani Galaxy T3 periodic maintenance checklist outlines daily, weekly, monthly, and annual tasks required for machine upkeep, including cleaning, lubrication, inspections, and replacements. Key tasks include verifying blade sharpness, checking alignment, and inspecting safety devices. Standard notes emphasize safety protocols and the use of approved parts and maintenance logging.

Uploaded by

Hayat Hyt
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd

GABBIANI GALAXY T3 - PERIODIC MAINTENANCE CHECKLIST

Interval Component / Area Maintenance Task

Daily Machine surfaces / work table Clean surfaces, sliding parts, and table

Saw carriage / grippers / blade guard


Remove dust, chips, and debris

Pneumatic lines Check for air leaks

Dust extraction / suction hoods Clean dust extraction points

Saw blade Verify blade sharpness; replace if dull

Weekly Grippers Lubricate as per manual

Belts Inspect for tension and wear

Saw unit / scoring unit Check alignment

Saw carriage guides Clean and lubricate linear guides

Safety devices Inspect emergency stops, guards for proper operation

Monthly All bolts / fasteners Tighten loose screws, bolts, and fittings

Pusher carriage chain / rails Inspect and clean

Saw & scoring blade alignment Verify parallelism

Drive belts Check condition and clean

Lubrication unit Check oil level / refill

3-6 Months Machine frame / guides Check and correct alignment

(or 1000 hrs) Motors (main & scoring) Inspect bearings (noise, temperature)

Electrical cabinet Clean; check fans and filters

Sensors / encoders Verify operation

Air regulators / filters Clean / replace as needed

Annual Belts / bearings Replace worn components

Saw / scoring system Full calibration and accuracy inspection

Pneumatic system Replace air and lubrication filters

Software / control system Run diagnostics, check error logs

Dust extraction system Full check and cleaning

Standard Notes:
- Always lock out and tag out power before performing maintenance.
- Use only manufacturer-approved parts, oils, and lubricants.
- Maintain a maintenance log for records and audits.

You might also like