I TSDR CATALOGUE I
I CONTENTS I
7FBEF15.16.18.20
Comfort ................................................................................................................Page 70
Special Cabin .......................................................................................................Page 71
Mast .....................................................................................................................Page 72
Driver’s overhead-guard accessories .................................................................... Page 74
Application package ............................................................................................. Page 76
Special Colour ......................................................................................................Page 78
Lighting .................................................................................................................Page 80
69
Comfort I 7FBEF
I COMFORT I
TWIN DIRECTION PEDAL Z70B
Feature : The standard direction switch lever is removed on that
modification. An additional pedal, conveniently located on the
left side of the toe board was added for driving in reverse mode.
The right pedal controls the forward mode. Unlike the 7FBMF
concept, this system is electrical. When depressing both pedals
at the same time, a built in circuit disconnects the function and
switches to neutral for enhanced safety.
Benefit : The operator can control the direction changes thanks
to 2 individual pedals.
AUTOMATIC SPEED REDUCTION SYSTEM ASK
Feature : Some photocells located on top of the overhead-guard
monitor permanently if the machine is entering or leaving the
zone where you want speed to be kept low. A reflector mounted
on the wall will reflect the signal emitted by the photo electric
cells and trigger the speed reduction mode.
Benefit : The customer can restrict speed in certain areas of his
premises and guarantee a safer application for all the people
working in the forklift surroundings.
BATTERY ROLL-OUT STOPPER MODIFICATION ASK
Features : This system is designed to avoid the lateral movement
of the battery when the forklift is cornering. The thread gives the
operator the possibility to adjust play and make sure that the
battery is safely secured in position.
Benefits :
Less Battery movement for even safer operation.
Less damage to the standard Battery lock.
70
Special cabin I 7FBEF
I SPECIAL CABIN I
STEEL CABIN FOR D56A BATTERY ROLL-OUT CHASSIS Z00A
Feature : Steel cabin for chassis with battery side-extraction.
Benefit : Operator protection in rainy or cold conditions.
71
Mast I 7FBEF
I MASTS I
SPECIFIC MASTS ASK
Feature : Mast modification including intermediate lift heights and higher lift heights for Toyota genuine masts.
V1700 // V5500 // V6000 // FSV4500 // FSV6500 // FSV7000 etc...
Benefit : Optimize mast lift height depending on application.
Extra Low Mast
V1700mm
on 7FBEF range
72
Mast I 7FBEF
HOSE REELS Z05A , Z06A , Z07A
Feature : The mast piping is re-located to the outside of the
mast.
Benefit : Better visibility through the mast.
73
Driver’s overhead guard accessories I 7FBEF
I DRIVER’S OVERHEAD-GUARD ACCESSORIES I
PIN-CODE KEYBOARD Z11B
Feature : Whenever customers have different operators, rather
than multiplying the number of ignition keys, the machine can
be fitted with a pin-code keyboard onto the dashboard.
Benefits :
- ABS shock resistant casing.
- 20 x driver codes
- Code Length : 4 Digits
- Waterproof (IP56 grade).
HAZARD LIGHTS FUNCTION ASK
Feature : The 4 x Turning signal lamps blink at the same time
when the operator pushes the button on the dashboard.
Benefit : Enhanced safety.
Notice : The Front & Rear Combination lights must be ordered
for this specification.
74
Driver’s overhead-guard accessories I 7FBEF
JOYSTICK ASK
Feature : An additional deadman switch (the red trigger)
That will lock the hydraulic functions till it is depressed. This
brings an additional safety level that combines to the genuine
S.A.S System.
1,2 or 3 x hydraulic functions
1 x optional direction
switch.
Benefit : For customers who prefer the functionality of the
Joystick rather than the original Mini-levers. Driver comfort.
Notice : In case the factory settings do not please the customer,
we can provide an optional plug-in interface for easy tuning.
This modification is based upon the Toyota
genuine mini-levers
Combination
with
Grammer
MSG30
2 x hydraulic
functions
variant
S.A.S fork
levelling system
button re-located
75
Application Package I 7FBEF
I APPLICATION PACKAGE I
INTERMEDIATE GRADE FISHERMAN ASK
Feature : Primer and final coatings are replaced with a high quality
400 micron thick poyurethan crust.
Benefit : Higher protection of the frame. Less paint flaking
problems. Integral spray of the chassis inside and outside. The
front of the machine is covered by a rubber sheet to increase
protection against water projections. Hydraulic connectors are
also additionally protected with a rust resistant paint.
Notice: For easy identification and differenciation by the end
user, the different zones of the machines painted with this
polyurethan coating will remain in blue. (Picture depicts the
FBESF range)
Rubber carpet for electric
motor protection.
400 µ Thick polyurethan Integral Chassis
protection inside & outside.
76
Application Package I 7FBEF
-30°C COLD STORAGE SPEC. ASK
Feature : This is our -30°Celcius specification for Cold Storage
applications. The machine is built around the B30F Fisherman
spec. as a base. The hydraulic circuit is filled with Low temperature
oil and the oil seals are changed to keep compatible with extreme
temperatures and avoid leakages.
Benefit : Better protection of the machine against moisture and
humidity.
Notice : For this specification, the B30F Fisherman spec must be
ordered separately.
77
Special colour I 7FBEF
I SPECIAL COLOUR I
CHASSIS SPECIAL COLOUR Z30A
MAST SPECIAL COLOUR Z30B
CABIN SPECIAL COLOUR Z30C
Feature : In case your customer needs any particular painting
scheme instead of our original colours, we can propose you a
wide range of possibilities.
Benefit : Own customer branded truck. // Customized.
Notice : Thanks in advance for sending us the document on the
next page indicating both RAL paint codes and the painting
scheme, area per area.
I.E : Special Painting Scheme on 7Series truck.
78
Special Colour I 7FBEF
G
Q
G
G K
A D S
B H H F
C E E E I
J
7FBEF Painting Scheme. TSDR Complementary Sheet. Please fill all the cells and send to TIEE Ancenis.
Accordingly to the latest EEC legislations, mast, fork carriage and load-backrest must stay in black colour.
Name of the contact Person : Date and Signature for approval :
79
Lighting I 7FBEF
I LIGHTING I
LIGHTING PATTERNS-LIGHTING SCHEMES
3
6
3
4
1 6
4
1
2
2
8
8
Please circle the type of light (A, B or C) and cirle the loaction requested on the forklift sketches.
Indicate order number(s) and send this document to the factory with your signature for approval.
7
Headlights
7
5
5
Combination Lights
Headlight
+ Position Light
+Turning Light
Rear working light
Pattern 1: Top of Overhead-Guard (A or B)
Date & Signature:
Pattern 2: Mid-Height (A or B)
Pattern 3: Mast Top Mounting (A or B)
Pattern 4: Mast Mid-Mounting (A or B)
Pattern 5: Double Rear Working Light (C)
80
