CO1: CONSTRUCT THE ENGINEERING CURVES AND PERFORM FREEHAND
SKETCHING.
Ex. No Description Marks (20)
1. Construct an ellipse when the distance of the focus from the directrix
is equal to 50 mm and the eccentricity is 2/3. Draw a tangent and a
normal to the ellipse at any point P on it.
2. Construct a parabola when the distance of the focus from the directrix
is equal to 55 mm. Draw a tangent and a normal to the ellipse at any
point P on it.
3. Construct a hyperbola, when the distance of the focus from the
directrix is 60 mm and the eccentricity is 3/2. Draw a tangent and a
normal to the hyperbola at any point P on it.
4. Draw a cycloid given the diameter of the generating circle as 50 mm.
Draw a tangent and a normal to the hyperbola at any point on it.
5. A circle of diameter 50 mm rolls on the outside of another circle of
diameter 180 mm without slipping. Draw the path traced by the point
on the smaller circle. Draw a tangent and a normal to the hyperbola
at any point on it.
6. Draw the top view, front view, and left side / right side view of the
object shown below.
7. Draw the top view, front view, and left side / right side view of the
object shown below.
8. Draw the top view, front view, and left side / right side view of the
object shown below.
9. Draw the top view, front view, and left side / right side view of the
object shown below.
10. Draw the top view, front view, and left side / right side view of the
object shown below.
Average
Viva
