Identify the reflection co efficient of a 50Ω transmission line when it is
terminated by a load impedance of 60+j40Ω.
. Justify the need of impedance matching?
. A lossless transmission line has a shunt capacitance of 100pF/m and a series
inductance of 4µ H/m. Determine the characteristics impedance.
For the line of zero dissipation, conclude the values of attenuation
constant and characteristics impedance?
What are loaded lines?
Examine the expression for the input impedance of a open circuit and short circuited
dissipation less line.
A transmission line has Zo = 745∟-12̊ Ω and is terminated in Z = 100Ω, calculate
reflection factor.
Define the smooth line.
50 Ω line operating at 1 GHz is terminated by a load of 20Ω.Determine the values of
maximum and minimum impedance.
Write the reason for standing waves and its elimination procedure.
Find the characteristics impedance of a line at 1600 Hz if Zoc =750
∟-30̊ Ω & Zsc = 600 ∟-20̊ Ω.
What is meant by distortion less line?
A lossless line has characteristics impedance of 400 Ω. Determine the
standing wave ratio if the receiving end impedance is 800+j0.0 Ω.
.Interpret the assumptions to simplify the analysis of line performance at
high frequencies?
.Define VSWR and write the expression for standing wave ratio in terms
of reflection co efficient?
.Explain Frequency distortion with respect to the reasons behind it.
Calculate the standing wave ratio and reflection co efficient on a line
having the characteristics impedance Z0 = 300Ω and terminating
impedance ZR = 300+j400Ω.
Illustrate Standing wave ratio.
.If VSWR of a line is 1.5 calculate reflection coefficient.
List the primary and secondary constants and state their characteristics.
Determine the general solution of a transmission line.
a)(i)The VSWR measured on UHF transmission line at a frequency of 3000MHz found to
be 2. If the distance between load and voltage minimum is 0.8m, determine the
normalized load impedance.
(8 marks)
ii)Explain Standing Wave Ratio in detail. (4 marks)
a)(i)The constant of LP transmission line per km are
R=6Ω,L=2.2mH,C=0.005μF,G=0.25μƱ. Calculate at the frequency of
1KHz,terminating impedance of which no reflection will be set up in the line and
attenuation in db suffered by signal at 1KHz, while travelling a distance of 100km
when the line is properly terminated and the phase velocity with which the signal
would travel.
(8 marks)
ii) Explain the Campbell’s Equation (6 marks)
Determine the transmission line equation and hence obtain the
expression for voltage and current on a transmission line.
a) (i)Examine the line constants of zero dissipation less line. (5marks)
(ii)Distinguish in detail about the variation of input impedance along
open and short circuit lines with relevant graph. (8marks)
A generator of 1V 1000Hz supplies power to a 100 km open wire line
terminated in Z0 and having following parameters R=10.4 ohm/km,
G=0.8x10 mho/km, L=0.00367 Henry/km, C=0.00835µF/km. Evaluate
α,β,λ,v, Z0 and received power.
