Material Safety Data Sheet
1. Product and Company Identification
Product Name: Lithium Grease for concrete pump equipment
Use: Concrete pump equipment
2. Composition：
Composition content Number Percentage %
Lithium-based crease 8002-05-9 > 80
Additive: Antioxidants, rust <5
inhibitors Tackifier
Saponification 36377-33-0 <15
agents:Dodecyl stearic acid
Stearic acid 57-11-4
Lithiumhydroxide 1310-66-3
3. Hazard statement:
Oral cavity– swallowing some lubricating grease will only cause abdominal discomfort,
nausea and vomiting.
Inhalation– This product will release odour gas when it is overheated. Trace products will
smell after heating. This product will not volatilize at room temperature. The fog and smoke
generated by the heating of this product in the enclosed space may also stimulate the
human body if they reach a certain concentration.
Skin– Short contact with this product may cause slight skin irritation. Long term contact may
cause local redness and swelling. Long term toxicological effect– according to IARC
standards, the base oil composition does not contain carcinogenic ingredients, and this
product will not have a chronic impact on human health after testing.
4. First aid measures.
Eyes– Immediately flush eyes with clean water for a few minutes. If symptoms do not
subside, seek medical advice immediately.
Skin– Wash the skin thoroughly with soapy water. If rash occurs due to excessive contact,
seek medical advice immediately. And wash the contaminated clothes.
Material Safety Data Sheet
Ingestion– If the person who takes it by mistake can still keep awake, take water or milk. Do
not make the patient vomit without the doctor's permission. Don't give anything to the
unconscious person. If medical advice cannot be obtained immediately, take the container
and sign to the medical centre.
Inhalation– In normal use, this product does not cause acute respiratory problems.
Treatment of acute wound: 1. Surgical decompression, debridement and drainage. 2. Take
broad-spectrum antibiotics. 3. Take anti-inflammatory drugs.
5. Firefighting measures
Flash point (º C): not measured Combustion limit: not determined Flash point (º C): not
measured Extinguishing agent usage– according to the guidance of the American Fire
Protection Association, water mist, dry chemical fire extinguishing and foam carbon dioxide
shall be used. Water or foam can cause foaming. Containers exposed to fire can be cooled
with water. Explosion hazard– as this product contains combustible ingredients, in order to
prevent burns and asphyxia, please wear an independent breathing device before entering
the open area.
6. First aid measures for external leakage
Leakage situation– shovel the leaked grease and put it into the waste container, and take
the precautions listed in this document. Wipe the contaminated area with a broom or mop
mixed with water and detergent. Absorb the liquid with absorbent. Avoid contact with eyes
and skin. Prevent this product from polluting various water sources.
7. Handling and storage- should be placed in a well-ventilated room with appropriate
temperature, and should not be exposed to sunlight
8. Exposure control/personal protection
Eyes- Avoid eye contact. Use chemical goggles or face shields.
Skin– Employees who do not take protective measures should practice using reasonable
personal cleaning: including washing exposed skin with soap and water every day, and
washing work clothes once a week.
Material Safety Data Sheet
Inhalation– No special protection is necessary when using this product at the lowest
possible temperature.
Ventilation- During normal use of this product, general dilution ventilation is sufficient.
9. Physical and chemical properties
Note: The following data only represent estimates or typical values for the same series of
products. Precise technical information can be obtained from the product brochures issued
by the market representatives.
Appearance and smell : light to brown, semi fluid
Boiling point (℃) : not determined
Vaporization pressure (mmHg @ 25 ℃) : low
Density (kg/l at 15 ℃) : 0.90
Vapor density (air=1) : not measured
PH value (undiluted) : N/A
Solubility (water) : Negligible
Volatile volume percentage : not determined
Evaporation : not determined
Viscosity : not measured
10. Stability and activation
Hazardous polymerization– does not occur
Combustible components of the product– conditions that should be avoided with paraffinic
distillates– high temperatures.
11. Toxicological information
General Information– This product contains petroleum base oils that have undergone multi-
step hydrotreating and solvent extraction. These oils are not included in the annual report
of the National Toxicology Program of the United States and the copy of the International
Agency for Cancer Research, and will not cause carcinogenic factors to human beings.
12. Ecological information
Environmental impact– This product will not cause long-term harm to the water
environment.
Material Safety Data Sheet
13. Handling Opinions
Waste disposal– put the pollutants into the dustbin and operate according to the disposal
specifications. Please contact local environmental and health authorities to obtain
permission to dispose of waste.
14. Delivery
UN value: N/A
Class of dangerous goods: N/A
Correct shipping name: N/A
Hazardous chemical labeling system code: N/A
15. Adjustment information
Respirator information: None
16. Additional information
To the best of our knowledge, the information provided in this material is completely correct.
If the user does not follow the operating instructions, we will not assume any responsibility.
Additional data may still be generated after the publication of this note. Some hazards have
been mentioned in this description, but not all possible hazardous effects are included. Use
with caution when unknown harmful effects occur
