Daily Safety Inspection Checklist Guide
Uploaded by
ScribdTranslationsDaily Safety Inspection Checklist Guide
Uploaded by
ScribdTranslationsSYSTEM OF MANAGEMENT OF SAFETY, HEALTH AT WORK AND ENVIRONMENT SST-F-57
DATE VERSION
PRE-OPERATIONAL INSPECTION
EQUIPMENT: Cutter Date : Project:
BASIC INSTRUCTIONS FOR PERFORMING THE SECURITY CHECK: The objective of this check is to identify the hazards specific to the area and the equipment with
the purpose of preventing risks that may materialize. Please note:
The safety checklist must be completed daily at the start of the activity.
2. Carry out the review and observe the conditions of the area carefully.
3. Evaluate the safety conditions according to the items listed on this sheet.
4. Mark according to: The requirement is fully met C
The requirement is not met NC
Not applicable NA
DAILY SAFETY INSPECTION
No. ITEM A INSPECT Week 1 Week 2 Week 3 Week 4
L M M J V S D L M M J V S D L M M J V S D L M M J V S D
Operator trained in the correct use of the equipment, by the provider or entity that
1 perform maintenance
2 The operator knows the technical operating manual.
Area free of elements that hinder operations such as cables on the floor, holes,
3 hanging elements, devices or materials
4 Evacuation route cleared and signposted
5 Área demarcada y señalizada
6 The external integrity of the equipment is in good condition.
7 The work table where the cutter is located is stable and safe.
9 Properly installed and adjusted the disk guard
10 Properly installed and adjusted the guard of the drive system
11 The drive system belt is in good condition
12 The cutting disc is in good condition and well adjusted.
The electrical connection is in good condition and protected from vehicle traffic.
13 people
14 The electrical control breaker is in good condition and well located.
15 There is a fire extinguisher for fire control near the work area.
16 The operator makes use of the necessary personal protective equipment for the activity.
NAME OF THE WORKER WHO PERFORMS THE INSPECTION
ADDITIONAL OBSERVATIONS:
SYSTEM OF MANAGEMENT OF SAFETY AND HEALTH IN WORK AND ENVIRONMENT SST-F-56
DATE VERSION
PRE-OPERATIONAL INSPECTION
11/30/2019 0
Equipment: Rotary Hammer Drill Fecha : Del: Al: Month: Project:
BASIC INSTRUCTIONS FOR CONDUCTING THE SECURITY CHECK: The objective of this check is to identify the hazards specific to the area and the equipment.
in order to prevent the risks that may materialize. Please note:
The safety checklist must be completed daily at the start of the activity.
2. Conduct the review and observe the conditions of the area carefully.
[Link] the safety conditions according to the items listed on this sheet.
4. Mark according to: The requirement is fully met C
The requirement is not met NC
Not applicable NA
IF ANY REQUIREMENT IS NOT FULLY MET, THE EQUIPMENT MUST NOT BE USED.
DAILY SAFETY INSPECTION
No. ITEM A INSPECT Week 1 Week 2 Week 3 Week 4
L M M J V S D L M M J V S D L M M J V S D L M M J V S D
Trained operator in the correct use of the equipment, by the supplier or
1 entity that performs the maintenance.
2 Operator knows the technical operation manual
3 The drill to be used is the correct one according to the equipment.
4 The power cable is in good condition.
5 The electrical extension is in good condition.
6 The drill is in good condition
7 The drill body is in good condition.
8 The ignition works
9 The trigger works correctly
The operator makes use of the necessary personal protective equipment for the
10 activity
NAME OF THE WORKER WHO CARRIES OUT THE INSPECTION
ADDITIONAL OBSERVATIONS:
