Presented By: Gopal Chandra Nepal Dramzob
It generates output without giving input and with no Phase Shift.
Copyright Reserved
Gopal Chandra Nepal & Dramzob
Uses two RC networks connected to the positive terminal to form a frequency selective feedback network Causes Oscillations to Occur
Copyright Reserved
Gopal Chandra Nepal & Dramzob
Amplifies the signal with the two negative feedback resistors
Copyright Reserved
Gopal Chandra Nepal & Dramzob
Two RC network must have equal resistor and capacitor values. R1=R2=R C1=C2=C R4= 2*R3
Copyright Reserved
Gopal Chandra Nepal & Dramzob
When the Wiens Bridge is balanced Gain must be 3. The gain can be found by:
R3 R 4 Gain R3
R3 2 * R3 Gain 3 R3
Copyright Reserved Gopal Chandra Nepal & Dramzob 6
4.0V
G=3
0V
-4.0V 0s V(R5:2) Time 4.0V 0.2ms 0.4ms 0.6ms 0.8ms 1.0ms
G = 2.9
0V
-4.0V 0s V(R5:2) Time 20V 0.2ms 0.4ms 0.6ms 0.8ms 1.0ms
0V
G = 3.05
-20V 0s 100us V(R5:2) 200us 300us Time 400us 500us 600us
Copyright Reserved
Gopal Chandra Nepal & Dramzob
The values calculated are: R1=R2=R = 10K, C1=C2=C= 0.22F R3 = 10K. R4 = 2*R3= 20K
2 RC 1 1 72 .34 Hz 2 * *10 k * 0.22
10K 20K Gain 3 10K Gopal Chandra Nepal & Dramzob Copyright Reserved
Copyright Reserved
Gopal Chandra Nepal & Dramzob
Diode is added to the circuit diagram to make the oscillation steady. The Diode network keeps Gain around 3. The Gain(G) is still equal to 3.
Copyright Reserved
Gopal Chandra Nepal & Dramzob
10
Copyright Reserved
Gopal Chandra Nepal & Dramzob
11
Input Voltage
Output Voltage
Copyright Reserved
Gopal Chandra Nepal & Dramzob
12
Simulation Result Simulation Frequency = 71.94Hz Theoretical Frequency= 72.34Hz
Practical Result Practical Frequency= 71.43Hz Theoretical Frequency= 72.34Hz
72.34 71.94 Error (%) 100 72.34 0.55%
72.34 71.43 Error (%) 100 72.34 1.26%
Copyright Reserved
Gopal Chandra Nepal & Dramzob
13
The error is caused due to:
1. Use of non-ideal Op-Amp. 2. The values of resistors were not exact. 3. Due to resistance offered by connecting wires.
Copyright Reserved
Gopal Chandra Nepal & Dramzob
14
Precautions to be taken:
1. While using diode keep gain slightly greater than 3. 2. Check Op-Amp and other device for its functioning. 3. Check the connections.
Copyright Reserved
Gopal Chandra Nepal & Dramzob
15
No input yet produces output. Can output large range of frequencies. The gain of amplifier must be around 3. With proper configuration oscillation can go on indefinitely. Due to limitation of Op-Amp frequencies above 1MHz cannot be achieved. There is no phase shift.
Copyright Reserved Gopal Chandra Nepal & Dramzob 16
John. (2009, October) Circuits Today. [Online]. http://www.circuitstoday.com/wien-bridge-oscillator Wayne Storr. (200_) Electronics Tutorials. [Online]. http://www.electronics-tutorials.ws/oscillator/wien_bridge.html G. Ramakant, Op-Amps and Linear Integrated Circuits, 4th ed. India: Prentice Hall of India Pvt. Ltd., 2006. Robert Boylestead and L. Nashelsky, Electronics Devices and Circuit Theory, 6th ed. New Delhi, India: Prentice-Hall of India pvt Ltd, 2001. M. M. S. Anand, Electronic Instruments and Instrumentation Technology, 7th ed. New Delhi, India: PHI Learning Private Limited, 2001. Copyright Reserved Gopal Chandra 17 D. D. Ronde.(May,2002), WiensNepal & Dramzob Bridge Oscillator
Copyright Reserved
Gopal Chandra Nepal & Dramzob
18
Copyright Reserved
Gopal Chandra Nepal & Dramzob
19
