Scribd
Upload
833 views4 pages

Conexión Piasini RF8. Mazda 6 2009 Tnx.

The document provides instructions for connecting an ECU flat cable and reading or writing the ECU. It states to connect the red wire to power and black wire to ground. For reading the ECU, connect the flat cable pins to the corresponding numbers shown in a picture. For writing the ECU, place two wires as a bridge as shown in another picture.

Uploaded by

Maikel González
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
833 views4 pages

Conexión Piasini RF8. Mazda 6 2009 Tnx.

The document provides instructions for connecting an ECU flat cable and reading or writing the ECU. It states to connect the red wire to power and black wire to ground. For reading the ECU, connect the flat cable pins to the corresponding numbers shown in a picture. For writing the ECU, place two wires as a bridge as shown in another picture.

Uploaded by

Maikel González
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

Connect as below:

Serial Suite:
Red Black to to

ECU Plug:
1 Pins Red (Power Supply +12 Volt) 1 Pins Black (Ground)

Piasiniengineering [email protected] http://www.piasiniengineering.it Tel: +39 0342 489060 - Fax: +39 0342 488298

Where to connect the flat cable:

After you have open the ECU, you have to clean the pins like in the picture.

Piasiniengineering [email protected] http://www.piasiniengineering.it Tel: +39 0342 489060 - Fax: +39 0342 488298

READ the ECU:

Connect the flat cable pin following the number like in picture.

Piasiniengineering [email protected] http://www.piasiniengineering.it Tel: +39 0342 489060 - Fax: +39 0342 488298

WRITE the ECU:

For write the ECU put 2 wire(Bridge) like in the picture.

Piasiniengineering [email protected] http://www.piasiniengineering.it Tel: +39 0342 489060 - Fax: +39 0342 488298

You might also like