Scribd
Upload
35 views1 page

Figure 1: Weather-Resistant Rain Detector

The document describes a simple rain detector circuit that uses aluminum foil strips on plastic with a zig-zag cut to separate the leads. When rain drops bridge the gap between foil strips, it completes a circuit that triggers a beeper, alerting the user to rain and allowing time to close windows before a storm. The schematic shows the rain detector connected to a transistor, resistor and beeper circuit powered by AA batteries to sound an alarm when the foil is bridged by rain drops.

Uploaded by

Juan José GC
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
35 views1 page

Figure 1: Weather-Resistant Rain Detector

The document describes a simple rain detector circuit that uses aluminum foil strips on plastic with a zig-zag cut to separate the leads. When rain drops bridge the gap between foil strips, it completes a circuit that triggers a beeper, alerting the user to rain and allowing time to close windows before a storm. The schematic shows the rain detector connected to a transistor, resistor and beeper circuit powered by AA batteries to sound an alarm when the foil is bridged by rain drops.

Uploaded by

Juan José GC
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Plastic backing

Aluminum foil
(Affix with spray glue.)
Bare wire completely
under foil for protection
Insulated wire leads
Strip back sufficient
insulation to ensure good
contact.
Figure 1: Weather-resistant rain detector.
4.5 Volts
(3 AA cells)

Beeper
+
2N4401
1k
220
100k
1k
It may sound silly at first. After all, how hard is it to look outside to see if it is raining. But if you
start to pay attention, you will be surprised how often you miss the start of a rain storm. With this
simple rain detector, the first few drops of rain will sound the alarm allowing you a few precious
seconds to roll up windows and bring in possessions. When used as part of a computer weather
data collection system, the exact time of a shower may be recorded.

Fig.1 shows a simple rain detector consisting of two strips of aluminum foil glued to a piece of
plastic. A single square of foil is glued to the plastic with two lead wires underneath as shown in
the figure. The lead wires are striped back so that the foil makes good electrical contact with the
conductors but the bare wire should not protrude so that the foil will protect the wire from
corrosion.
Figure 2: Schematic of rain detector.
Rain Detector
A narrow zig-zag gap is cut in the foil to electrically separate the two lead wires. The rain drops
bridge the gap causing conduction which is sensed by the circuit shown in fig. 2.
2N4403
A 9 volt battery will also work with
the indicated values.

You might also like