Saint Basils Cathedral, Russia : Assembly Instructions
Before starting assembly :
Writing the number of each section on its back side before
cutting out the sections is highly recommended.
(* This way, you can be sure which section is which even after
cutting out the sections.)
Glue the rear sides of
the upper parts of
View of completed model
* This model was designed for Papercraft and may differ from the original in some respects.
Assembly Instructions : Eight US letter sheets (No. 1 to No. 8)
* Build the model by carefully reading the Assembly Instructions , in the parts sheet page order.
*Hint: Trace along the folds with a ruler
and an exhausted pen (no ink) to get a sharper, easier fold.
Assembly Instructions
Mountain fold(dotted line)
Make a mountain fold.
Valley fold(dashed and dotted line)
Make a valley fold.
Scissors line(solid line)
Cut along the line.
Cut in line(solid line)
Cut along the line.
Tools and materials
Assembly tip
Caution
Glue
The glue spot(colored dot)
shows where to apply the glue.
Glue spot(Red dot)
Glue parts with the same number together.
Glue spot(Green dot)
Glue within the same part.
Glue spot(Blue dot)
Glue to the rear of the other part.
Scissors, set square, glue(We recommend stick glue), pencil, used
ballpoint pen, toothpicks, tweezers, (useful for handling small parts)
Before gluing, crease the paper along mountain fold and valley
fold lines and make sure rounded sections are nice and stiff.
Glue, scissors and other tools may be dangerous to young children
so be sure to keep them out of the reach of young children.
Indicates where sections should
be glued together.
Indicates where to insert sections.
Do not glue the sections together.
Saint Basils Cathedral, Russia : Assembly Instructions
Glue the rear sides of the cross.
Roll them to make
round in advance, and
paste 8 pieces together
in the same way.
Saint Basils Cathedral, Russia : Assembly Instructions
Saint Basils Cathedral, Russia : Assembly Instructions
Reinforcement parts
Saint Basils Cathedral, Russia : Assembly Instructions
Saint Basils Cathedral, Russia : Assembly Instructions
Saint Basils Cathedral, Russia : Assembly Instructions
Glue the post parts 72,73
to the inside of the part 70.
Glue the pasting margins of
part 70 to the rear side of
the floor part 71.
Saint Basils Cathedral, Russia : Assembly Instructions
Glue the rear sides of the leaf area.
Finished!