SERVICE BULLETIN
QUALITY INFORMATION ANALYSIS
OVERSEAS SERVICE DEPT. MITSUBISHI MOTORS CORPORATION
SERVICE BULLETIN
Subject:
Group:
No.: MSB-98E13-502
Date: 1999-07-15
ADDITION OF CAUTION CONCERNING
THROTTLE ACTUATOR THROTTLE VALVE
STOPPER SCREW
Draft No.: 98JY542415
FUEL
CORRECTION
OVERSEAS
SERVICE
DEPT
<Model>
(EC,EXP)GALANT
(E50-80)
<M/Y>
97-10
T.NITTA - VICE GENERAL MANAGER
QUALITY INFORMATION ANALYSIS
1. Description:
Caution has been added concerning the throttle actuator throttle valve stopper screw.
2. Applicable Manuals:
Manual
97 GALANT
Workshop Manual CHASSIS
Pub. No.
PWDE9611
PWDS9611
PWDF9611
PWDG9611
PWDD9611
PWDW9611
Language
Page(s)
(English) 13E-61
(Spanish)
(French)
(German)
(Dutch)
(Swedish)
13E-61
DIESEL FUEL- On-vehicle Service
3. Connect a hand vacuum pump to nipple B of the solenoid valve.
4. Use jumper wires to connect the terminals of the solenoid valve and
the battery.
5. Check the air-tightness when negative pressure is applied while the
jumper wire is connected to the battery (-) terminal and while it is
disconnected.
Normal condition:
Battery
DFU0677
Jumper wire
Connected
Nipple A condition
Open
Closed
Disconnected
Open
Normal condition
Negative pressure
leaks
Negative pressure is
maintained
Negative pressure
leaks
6. Measure the resistance between the terminals of the solenoid
valve.
Standard value: 36 44 (at 20)
THROTTLE ACTUATOR CHECK
Throttle actuator
13300740016
1. Remove the vacuum hose (red stripe) from the throttle actuator and
connect a hand vacuum pump to the throttle actuator nipple.
2. Check that the actuator rod moves smoothly when applying
vacuum gradually. Also, check the vacuum is maintained when
applying 53 kPa of vacuum.
Throttle valve stopper screw
DFU0683
<Added>
INJECTION NOZZLE CHECK AND ADJUSTMENT
13300700020
Caution
Never touch the injection spray that is injected from the nozzle.
FUEL INJECTION INITIAL PRESSURE CHECK
01R0528
<Added>
Caution
1. The throttle valve stopper screw has
precisely been adjusted at the factory.
Therefore, the screw is very difficult to
readjust. The screw must not be
disturbed.
2. Should the screw be out of
adjustment, replace the throttle body
assembly.
1. Install the injection nozzle to a nozzle tester.
2. Move the lever of the nozzle tester 2 3 times to inject fuel and to
bleed the air.
3. Gently press down the lever of the nozzle tester, and take a reading
of the indication value on the pressure gauge at the point where the
needle slowly rises and then suddenly drops.
Standard value: 14.710- 15,690 kPa