DIgSILENT Technical Documentation
GE 469
PowerFactory
Relay model description
DIgSILENT GmbH
Heinrich-Hertz-Strasse 9
D-72810 Gomaringen
Tel.: +49 7072 9168 - 0
Fax: +49 7072 9168- 88
http://www.digsilent.de
e-mail: [email protected]
GE 469
PowerFactory
Relay model description
Published by
DIgSILENT GmbH, Germany
Copyright 2009. All rights
reserved. Unauthorised copying
or publishing of this or any part
of this document is prohibited.
doc.TechRef, Build 511 05 Dezember 2012
Table of Contents
Table of Contents
1 MODEL GENERAL DESCRIPTION ........................................................................................................................... 4
2 RELAY NOT SUPPORTED FEATURES ...................................................................................................................... 5
GE 469
Power Factory relay model description
1 Model general description
The following functionalities are modelled:
Three-phase thermal model (Thermal model and K block, simplified model)
Short circuit trip (Short circuit trip and Short circuit trip backup block)
Overload alarm (Overload alarm block)
Mechanical jam (Mechanical jam block)
Undercurrent (Undercurrent trip and Undercurrent alarm block)
Current Unbalance (Current Unbalance block)
Ground fault (Ground fault trip and Ground fault alarm block)
Undervoltage (Undervoltage alarm and Undervoltage trip block)
Overvoltage (Overvoltage alarm and Overvoltage trip block)
Frequency (Overfrequency trip, Overfrequency alarm, (Underfrequency trip, Underfrequency alarm block)
Power factor (Power factor alarm, Power factor lead alarm, Power factor lead trip, Power factor lag alarm,
Power factor lag trip block)
Reactive power (Reactive power alarm, Reactive power lead alarm, Reactive power lead trip, Reactive power
lag alarm, Reactive power lag trip block)
Under power (Under power alarm, Under power lead alarm, Under power lead trip, Under power lag alarm,
Under power lag trip block)
Current differential (Differential block). Please note that to work correctly the Remote Ct -3p CT must be set to
have the opposite orientation of the Ct-3p CT. Example: if the Ct-3p orientation is -> branch, the Remote Ct 3p orientation must be -> busbar.
GE 469
Power Factory relay model description
2 Relay not supported features
The following features are not supported:
Voltage dependent overload curves
Acceleration timer
Start inhibit
Jogging block
Restart block
RTD features
Phase reversal
Overtorque
Starter failure
GE 469
Power Factory relay model description
