Scribd
Upload
182 views3 pages

How To Upgrade The Software

If the Software upgrading process did not start correctly, The TV will turn on in a normal viewing mode. While The TV is upgrading no indication will appear on The TV screen but the upgrade is in process. Press "MENU" button on the remote controller and select "Install and Retune" by using "Left" or "Right" button.

Uploaded by

Иван Алексиев
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
182 views3 pages

How To Upgrade The Software

If the Software upgrading process did not start correctly, The TV will turn on in a normal viewing mode. While The TV is upgrading no indication will appear on The TV screen but the upgrade is in process. Press "MENU" button on the remote controller and select "Install and Retune" by using "Left" or "Right" button.

Uploaded by

Иван Алексиев
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

NOTE; PERSONAL AND CUSTOM PREFRERENCES WILL BE LOST UPON COMPLETION

OF THIS FIRMWARE UPDATE. PLAEAE MAKE NOTE OF ANY PREFERENCE SETTINGS


PRIOR TO STARTING THIS FIRMWRE UPDATE.

How to upgrade the Software


1

Remove AC power from set by unplugging the AC power cord with viewing the TV.

The USB reader is located on the left of the cabinet near the side control/jack assembly as shown in
Figure1.

Figure1

Copyright 2012

All Rights Reserved

Page 1 of 3

Insert the USB Drive into the USB slot as shown in Figure2.

Figure2

Power On the set from Standby and immediately after that press OK key on the remote control and
keep it pressed until the front LED starts to blink rapidly.

While the TV Software is upgrading, the Standby LED indicator will blink in red rapidly.
Note: If the Software upgrading process did not start correctly, the TV will turn on in a normal
viewing mode. You must then re-start the Software upgrade process from step1.
While the TV is upgrading no indication will appear on the TV screen but the upgrade is in process.
DO NOT unplug the AC power to the TV or press any buttons on the remote controller or
the TV keypad during this process.

Upon completion, TV will reboot automatically.

Remove the USB Drive from the reader slot.

Press MENU button on the remote controller and select Install and Retune by using Left or
Right button to perform the First time installation function.
Press OK button and the following menu screen will be displayed as showing figure6.

Figure6

Copyright 2012

All Rights Reserved

Page 2 of 3

Select First time installation by using Up or Down button and press OK button.
Do you want to delete all channels and setting for first time installation? will be displayed.
Select Yes and press OK button.
First time installation will be displayed as shown figure7.

Figure7
Follow the instructions on the screen and consult the owners manual for the first time installation.

The TV upgrade is now complete.

Copyright 2012

All Rights Reserved

Page 3 of 3

You might also like