Scribd
Upload
217 views

"Sarong Wrap Pants": Supplies

This document provides instructions for making a pair of sarong wrap pants using two rectangles of fabric and ribbon. The key steps are to cut the fabric into two pieces and stitch them together at the crotch seam. A casing is made by folding the waist edges to enclose ribbon that is threaded through. The pants are finished by hemming the edges and securing the ribbon in the casing.

Uploaded by

hamba_dah
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
217 views

"Sarong Wrap Pants": Supplies

This document provides instructions for making a pair of sarong wrap pants using two rectangles of fabric and ribbon. The key steps are to cut the fabric into two pieces and stitch them together at the crotch seam. A casing is made by folding the waist edges to enclose ribbon that is threaded through. The pants are finished by hemming the edges and securing the ribbon in the casing.

Uploaded by

hamba_dah
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

Sarong Wrap Pants

With just a few easy steps, you can turn two


squares of fabric and some ribbon into this
seasons comfiest trend - a pair of sarong
wrap pants!
Created by: Kelly Laws, Marketing Project
Manager

Supplies:
Baby Lock Sewing Machine or serger
2 yards 58 -60 wide lightweight knit fabric
5 yards 1 wide satin ribbon
All-purpose thread
Woolly thread for serger (OPTIONAL)
Chalk
Bodkin (or large safety pin)
Tape measure
Scissors

Instructions:
1. Cut two rectangles of fabric 30 x 50.
2. Fold them in half so you have two 30 x 25 pieces and stack them
matching the fold edges.

3. Using the tape measure and chalk mark the following measurements on
the fold edge.

Totally Stitchin Project: Sarong Wrap Pants

Page 1 of 3

4. Cut a curved line and remove the top corner piece.

5. Open the rectangles and match the right side of the fabric.
6. Stitch the two pieces together at the curve. This will form the crotch seam
of the wrap pants.

7. Find the edges with the seams. These will be the center front and center
back waist seams. Fold over 1-1/2 to form the waist line casing. Stitch
along the edge leaving the ends open to run the ribbon through.

Totally Stitchin Project: Sarong Wrap Pants

Page 2 of 3

8. To finish the edges on the wrap pants use a three thread rolled hem with
the serger or a small zigzag stitch with the sewing machine along the
sides and hem. For a softer hem use woolly nylon in both loopers of the
serger.
9. Cut the 5 yard piece of ribbon in half. Use a bodkin or large safety pin to
run a piece of ribbon through the front and back casings.
10. Sew a small seam through all layers of the casing at the seam to secure
the ribbon from slipping out of the casing.

To wear your sarong wrap pants:


1. Wrap the front around your waist and tie the ribbon.
2. Pass the back casing between your legs, wrap the back to the front
and tie around your waist.

For other exciting projects like this one, visit our Web site at totallystitchin.net

Totally Stitchin Project: Sarong Wrap Pants

Page 3 of 3

You might also like