Scribd
Upload
365 views4 pages

ECU Connection Instructions

The document provides instructions for connecting a flat cable to read and write an ECU. To read the ECU, connect the red wire of the flat cable to pin 1 and the black wire to pin 2. To write the ECU, connect as instructed in the pictures and add either a 1uF capacitor for the front connection or a bridge wire for the back connection.

Uploaded by

Alexandre Da Silva Pinto
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
365 views4 pages

ECU Connection Instructions

The document provides instructions for connecting a flat cable to read and write an ECU. To read the ECU, connect the red wire of the flat cable to pin 1 and the black wire to pin 2. To write the ECU, connect as instructed in the pictures and add either a 1uF capacitor for the front connection or a bridge wire for the back connection.

Uploaded by

Alexandre Da Silva Pinto
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

Connect as below:

Serial Suite:
Red
Black

ECU Plug:
to
to

1 Pins Red (Power Supply +12 Volt)


1 Pins Black (Ground)

Piasiniengineering [email protected] http://www.piasiniengineering.it


Tel: +39 0342 489060 - Fax: +39 0342 488298

Where to connect the flat cable:

Backside:

Piasiniengineering [email protected] http://www.piasiniengineering.it


Tel: +39 0342 489060 - Fax: +39 0342 488298

READ the ECU:

For read the ECU connect the flat cable following the red number in the picture.

Piasiniengineering [email protected] http://www.piasiniengineering.it


Tel: +39 0342 489060 - Fax: +39 0342 488298

WRITE the ECU:


Front:

For write the ECU put 1 capacitor(1uF) and connect the flat cable following the
number in the picture.

Back:

For write the ECU put 1 wire(bridge) and connect the flat cable following the number
in the picture.
Piasiniengineering [email protected] http://www.piasiniengineering.it
Tel: +39 0342 489060 - Fax: +39 0342 488298

You might also like