0% found this document useful (0 votes)
104 views2 pages

PIC24FJ32GB002

Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
104 views2 pages

PIC24FJ32GB002

Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

PIC24FJ32GB002

Parameter Name Value

Architecture 16-bit

CPU Speed (MIPS) 16

Memory Type Flash

Program Memory (KB) 32

RAM Bytes 8,192

Temperature Range C -40 to 125

Operating Voltage Range (V) 2 to 3.6

I/O Pins 21

Pin Count 28

System Management Features BOR, LVD

Internal Oscillator 8 MHz, 32 kHz

nanoWatt Features Low Sleep/Fast Wake/Fast Control

Digital Communication Peripherals 2-UART, 2-SPI, 2-I2C

Analog Peripherals 1-A/D 9x10-bit @ 500(ksps)

Comparators 3

USB (ch, speed, compliance) 1, Full Speed, USB 2.0 OTG

Capture/Compare/PWM Peripherals 5/5

16-bit PWM resolutions 16

Timers 5 x 16-bit

Parallel Port PMP

Hardware RTCC Yes

XLP Yes

Cap Touch Channels 9

Features
CPU

 Up to 16 MIPS performance
 16 x 16 Hardware Multiply, Single Cycle Execution
 32-bit x 16-bit Hardware Divider
 C Compiler Optimized Instruction Set System
 Internal oscillator support - 31 kHz to 8 MHz, up to 32 MHz with 4X PLL
 On-chip LDO Voltage Regulator
 JTAG Boundary Scan and Flash Memory Program Support
 Fail-Safe Clock Monitor – allows safe shutdown if clock fails
 Watchdog Timer with separate RC oscillator
 nanoWatt Power Managed Modes
 Run, Idle and Sleep modes
 Deep sleep mode for lowest current consumption

Multiple, Switchable Clock Modes for Optimum Performance and Power Management

Analog Features

 10-bit ADC, 9 channels, 500k samples per second


 3 analog comparators

Other Peripherals

 2 UART Modules with LIN and IrDA® support, 4 Deep FIFO


 2 SPI Modules with 8 Deep FIFO
 2 I2C Modules with Master and Slave Modes
 Five 16-bit Timer Modules
 Up to 5 Input Capture and 5 Output Compare / PWM, all with dedicated timers
 Hardware RTCC, Real-Time Clock Calendar with Alarms
 PMP, Parallel Master Port, with 16 Address Lines, and 8/16-bit Data
 Peripheral Pin Select for remapping digital peripherals to I/O

Charge Time Measurement Unit (CTMU) for capacitive touch interface

 Universal Serial Bus Features


 USB v2.0 On-the-Go compliant
 Dual role capable, can act as either Host or Device
 Low Speed(1.5Mb/s) and Full Speed(12 Mb/s) operation in Host mode
 Full speed USB operaton in Device mode
 Supports 32 endpoints
 On-chip USB transceiver
 Opcional PIC24FJ32GB004

You might also like