Scribd
Upload
54 views5 pages

DS-33151 Manual English 20110523

This document provides a user manual for an IDE to SATA converter board. The board allows a Serial ATA device to connect to a computer using an IDE/PATA interface. It converts Serial ATA commands to IDE and vice versa. The board supports transfer speeds up to 1.5GB/s on the SATA side and is compatible with Ultra ATA-133 on the IDE side. Installation instructions are provided and require selecting the device as master or slave, connecting the SATA device to the board, connecting the IDE cable correctly, and connecting the power cable.

Uploaded by

jbidouillelivefr
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
54 views5 pages

DS-33151 Manual English 20110523

This document provides a user manual for an IDE to SATA converter board. The board allows a Serial ATA device to connect to a computer using an IDE/PATA interface. It converts Serial ATA commands to IDE and vice versa. The board supports transfer speeds up to 1.5GB/s on the SATA side and is compatible with Ultra ATA-133 on the IDE side. Installation instructions are provided and require selecting the device as master or slave, connecting the SATA device to the board, connecting the IDE cable correctly, and connecting the power cable.

Uploaded by

jbidouillelivefr
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 5

IDE - SATA

Converter

User Manual

1
Introduction
This Bridge Board is a converter solution for the Serial ATA Device. It
has a standard 22 pin SATA port which can interface to a Serial ATA
device (hard disk, CDROM, DVD, CD-RW, etc). It accepts Parallel
ATA (IDE) commands through the 40 pin IDE connector form the host,
decodes the commands and converts them to Serial ATA commands to
the device. Response from the device through the SATA bus are
deciphered, processed and converted to parallel ATA protocol and sent
to the host.
The SATA 150 to PATA Converter supports the Serial ATA Generation
1 transfer rate of 1.5GB/s (150MB/s) on the Serial ATA side and is
compatible with Ultra ATA-133 on the parallel ATA side.

Features
Overall Features
Compatible with Ultra ATA 133 / 100 / 66 / 33 specifications
Supports all types of SATA storage devices (DVD, DVD-RAM,
MO, CD-ROM, CD-RW, Hard Disk, …)
100% hardware bridge converter to support PC and MAC
environment

2
Serial ATA Features
Compliant with Serial ATA 1.0 specifications
Supports Serial ATA Generation 1 transfer rate 1.5Gb/s

Hardware Installation
1. Decide the master or
slave of this future IDE
device choose the right
choice by jumper.

2. Connect the SATA 150 to

3
PATA Converter to your
SATA device.

3. Plug the IDE cable to


SATA 150 to PATA
Converter and please
remind the direction of
IDE PIN.

4. Plug the 4 PIN power


cable to SATA 150 to
PATA Converter.

4
Note: Please make sure that your PC is shut down during
your hardware installation. This SATA 150 to PATA
Converter with your SATA device is not hot swap device
and please shut down your computer before your want to
connect this device.

You might also like