Scribd
Upload
199 views

Satellite Communication Lab Stc10

The C & S Band Satellite Communication Lab STC10 is a device for simulating satellite communication systems. It contains uplink and downlink transmitters and receivers, a satellite emulator, and various antennas and accessories. The lab allows experiments on analog and digital signal transmission over satellite links and studies of modulation, fading, noise, and other effects.

Uploaded by

Carbon Nano Tube
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
199 views

Satellite Communication Lab Stc10

The C & S Band Satellite Communication Lab STC10 is a device for simulating satellite communication systems. It contains uplink and downlink transmitters and receivers, a satellite emulator, and various antennas and accessories. The lab allows experiments on analog and digital signal transmission over satellite links and studies of modulation, fading, noise, and other effects.

Uploaded by

Carbon Nano Tube
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

C & S BAND SATELLITE COMMUNICATION LAB STC10

Satellite Communication Lab STC10 Features: * 7 PLL Uplink 5.8GHz & 4 Downlink channels in 2.4 GHz. * Tele-command and telemetry facility * Different Baud rates USB PC-PC link. * Emulation of variable signal fading, variable thermal noise * Variable propagation delay. * Variable path loss at downlink channel * LCD display of PLL synthesized frequency in Transmitter, Receiver and Satellite Emulator * Gold Plated SMA connectors. * Dish, Patch array for linear & circular polarization. * C/N and S/N measurement facility 1. Satellite Uplink Transmitter Technical specifications: Frequency range : 4 channels in 2.4 GHz PLL controlled Accuracy : 0.01% Display : 16X2 Backlit LCD : 50 Ohms Unbalanced SMA RF Input Z : -85dBm Sensitivity : Speaker inbuilt/output Audio 1out : Speaker inbuilt/output Audio 2out : 5MHz bandwidth, 1V p/p Video Out : Max bit rate 100KHz typical TTL Digital USB : PC serial port compatible output Down-converter : 400-500MHz output for spectrum analysis : 4 bit binary output with Selectable Telemetry 4 bit addresses : Tele-command Frame available at Valid/Error digital output Correction : Received signal strength output RSSI Out

Technical specifications: Frequency : 7 channels in 5.8 Ghz band ; PLL with frequency selection switch. Display : 16 X 2 Backlit LCD indication Spurious output : - 30 dB typical RF Output : 50 Ohms Unbalanced SMA RF output level : 0 dBm Typical Audio 1 & 2 : Int. 1KHz sine wave / Ext Mic Ext. Function Generator waveform Video : Analog Camera compatible Waveform : upto 5MHz Function Generator Digital : Max rate 100KHz typical Baseband : Transmits 3 signals simultaneously at each uplink frequency Tele-command : Selectable 4 bit binary input with selectable 4 bit addresses Enable : Telecommand Frame available at digital input Processor : 32 bit processor Bandwidth : 20 Mhz Modulation : 5/ 5.5MHz Audio FM Modulation 8 Mhz Video FM Modulation Power Supply : 100-240V AC 47-63Hz

3. Satellite link Emulator

2. Satellite Downlink Receiver

Technical Specifications: Transponder Uplink 7 channels in 5.8 Ghz band PLL Synth Frequency : Display : 16 x 2 backlit LCD -85dBm Sensitivity : : 4 bit binary output with Telemetry Selectable 4 addresses : Telemetry Frame available at digital Valid/Error output Correction Transponder Downlink Frequency range : 4 channels in 2.4GHz PLL controlled Display : 16X2 Backlit LCD

Mfd by: Amitec Electronics Ltd. Regd. Off: 504, Nilgiri, Barakhamba Road, New Delhi-110001, India Works: 4/32, Site-4, Industrial Estate Sahibabad, NCR Delhi-201010, India [email protected], www.amitecltd.com +91-120-4371276, +91-98118-39949, +91-98101-93153

C & S BAND SATELLITE COMMUNICATION LAB STC10


Technical specifications: Transponder Continued 0 dBm nominal RF output level : : 20dB Path Loss Tele-command : Selectable 4 bit binary input with selectable 4 addresses : Telecommand Frame at digital input Enable : Audio 1, Audio2, Video, Digital Test Output : Received signal strength output RSSI Out : Variable Noise addition : upto 0.6s on Audio1 channel Signal delay : variable Fading 7. Log periodic antenna S11: >10dB Bandwidth: 4 + 2 GHz Gain: 6dBi 0 Beamwidth : E plane 60 0 Beamwidth : H Plane 80 Polarisation : Linear Front to Back Ratio: 6dB Connector : SMA

4. Interference Generator Frequency: 0 . 1 - 3 G H z Harmonic Spacing: 10 MHz /50 MHz Frequency Stability: 100ppm Impedance: 50 Ohms RF level at 3m: 4 0 - 8 0 dBuV/m Radiant Field polarisation: Vertical and Horizontal

8. Microstrip Circular Patch Array 2 X 2 Fc :2.4 + 0.1 GHz S11 : 10 + 2dB Polarisation : Circular Gain : 7dBi Impedance : 50 Ohms Connector : SMA

5. Noise Figure Analyser

9. Microstrip Rectangular Patch Array 2 X 2 Fc :2.4 + 0.1 GHz S11 : 10 + 2dB Polarisation : Linear Gain : 9dBi Impedance : 50 Ohms Connector : SMA

Requires external DSO or Oscilloscope (minimum 20 MHz) 10. Parabolic Dish - 5.8 GHz Noise Source Frequency: DC-3000 MHz Harmonic Spacing: 0 (Noise); RF level: 12dB ENR Low Noise Amplifier; Frequency Range: 9KHz-4GHz Noise figure: 3dB, Gain: 20dB ; Compression 1dB: 10dBm Frequency: 50-500MHz; Resolution : 100KHz 4 digit LED display ; Range: -100dBm - +10dBm; Noise Figure: 4dB Input Impedance: 50 Ohms (SMA) Oscilloscope Output: Linear X, Log Y out (BNC) 500mV/10dB Filter: Video S11: >8dB Bandwidth: 5.8GHz Gain: 12dBi; 10dBi 0; Beamwidth : E plane30 0 Beamwidth : H Plane 45 Polarisation : Linear Front to Back Ratio: 10dB Connector : SMA

6. Parabolic Dish - 2.4 GHz S11: >10dB Bandwidth: 2.4GHz Gain: 10dBi 0 Beamwidth : E plane 40 0 Beamwidth : H Plane 60 Polarisation : Linear Front to Back Ratio: 10dB Connector : SMA

11. Microstrip rectangular Patch array - 5.8 GHz Fc :5.8 + 0.1 GHz S11 : 10 + 2dB Polarisation : Linear Gain : 7dBi Impedance : 50 Ohms Connector : SMA

Mfd by: Amitec Electronics Ltd. Regd. Off: 504, Nilgiri, Barakhamba Road, New Delhi-110001, India Works: 4/32, Site-4, Industrial Estate Sahibabad, NCR DELHI-201010, India [email protected], www.amitecltd.com +91-120-4371276, +91-98118-39949, +91-98101-93153

C & S BAND SATELLITE COMMUNICATION LAB STC10


12, 13. Axial Mode Helix LHCP 5.8 GHz & 2.4 GHz S11: >10dB, >10dB Bandwidth: 5.8 + 0.2GHz, 2.4 + 0.2GHz Gain: 4dBi, 6dBi 0, 0 Beamwidth : E plane 40 60 0,, Beamwidth : H Plane 100 1200 Polarisation : Circular Leftt Handed Front to Back Ratio: 6dB Connector : SMA 14, 15. Axial Mode Helix RHCP 5.8 GHz & 2.4 GHz S11: >10dB, >10dB Bandwidth: 5.8 + 0.2GHz, 2.4 + 0.2GHz Gain: 4dBi, 6dBi 0, 0 Beamwidth : E plane 60 60 0, Beamwidth : H Plane 100 1200 Polarisation : Circular Right Handed Front to Back Ratio: 6dB Connector : SMA 16. Camera Camera : Colour CCD Type Power Supply : From Tx Resolution : 400 Lines Size : 1/3" CCD Video O/P : 1Vp-p composite 19. Accessories 1) Experimental Manual 2) SMA-SMA Cable 2m - 2 Nos. 3) BNC Tee - 2 Nos. 4) BNC-BNC Cable - 6 Nos. 5) USB-cables - 2 Nos. 6) Antenna mounting Tripod E-Manual: Installation Video for ease of Learning Dimensions: 56X45X54cms Weight: 22Kgs Warranty: 3 yrs. Areas of Experimentation and scope of study * To setup UPLINK, DOWN LINK and functioning of transponder of a satellite. * To measure the baseband analog signal parameters in a satellite link. * To measure the signal parameters in an analog FM/FDMTV Satellite link. * To study the functionality of a satellite MODEM. * To study the phenomenon of Linear polarization. * To measure the C/N ratio. * To measure the S/N ratio. * To study the effect of fading and measure the fading margin of a received signal. * To measure the digital baseband signal parameters in a satcom link. * To setup a RS-232 satellite communication link using com ports of PC. * To calculate Bit Error Rate in a satcom link. * To measure the Propagation Delay of signal. * To measure pathloss. * To study noise. * To send telecommand and receive the telemetry Data.

17. Monitor Screen : 7" Colour LCD AV input : Analog Power Supply : Adapter Display Mode : 16 : 9 Viewing Angle : Wide Adjustable : Colour, Brightness, Contrast Remote control : card style

18. Serial Communication Software Serial communication software B a u d r a t e : 1 2 0 0 b ps 38,600bps Comport: User Selectable

Requires 2 external PC one at Tx end and other at Rx end

Mfd by: Amitec Electronics Ltd. Regd. Off: 504, Nilgiri, Barakhamba Road, New Delhi-110001, India Works: 4/32, Site-4, Industrial Estate Sahibabad, NCR Delhi-201010, India [email protected], www.amitecltd.com +91-120-4371276, +91-98118-39949, +91-98101-93153

You might also like