Scribd
Upload
3K views21 pages

1.pillar Trim PDF

The document discusses pillar trim topics including the nomenclature, thickness, and mounting of seven pillar trim parts. It describes generally increasing or decreasing the thickness of parts like the B-pillar, C-pillar, and A-pillar upper and lower sections. Criteria for dropping or increasing thickness include draft problems and increasing strength. Section criteria, fixations, and mounting to the body-in-white are also covered. Finally, general gap and biting conditions are addressed.

Uploaded by

satishasd
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
3K views21 pages

1.pillar Trim PDF

The document discusses pillar trim topics including the nomenclature, thickness, and mounting of seven pillar trim parts. It describes generally increasing or decreasing the thickness of parts like the B-pillar, C-pillar, and A-pillar upper and lower sections. Criteria for dropping or increasing thickness include draft problems and increasing strength. Section criteria, fixations, and mounting to the body-in-white are also covered. Finally, general gap and biting conditions are addressed.

Uploaded by

satishasd
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 21

Pillar Trim Topics 1. Nomenclature 2. Thickness for individual parts 3. Drop & increase thickness 4.

Section Criterias, fixations & mounting with BIW 5. General gap & biting conditions

Door Trim basically consists of seven parts basically in both front & rear door panel
Sr No 1 Part Name A PILLAR UPPER

A PILLAR LOWER

B PILLAR UPPER

B PILLAR LOWER

FRONT DOOR SILL

REAR DOOR SILL

C PILLAR UPPER

C PILLAR LOWER

Thickness, Drop & Increase thickness

B-pillar upper C-pillar upper A-pillar upper

B-pillar lower C-pillar lower

Rear door sill Front door sill A-pillar lower

Thickness, Drop & Increase thickness


Generally drop & increase thickness are done for increasing strength of the part at end condition.
B-pillar upper C-pillar upper A-pillar upper

B-pillar lower C-pillar lower

Rear door sill Front door sill A-pillar lower

Close 1 Increase Thickness Close 2 Drop

Drop Criteria Criteria for doing drop end condition

Drop Criteria Criteria for doing increase thickness at end condition For 9mm transition length there is a draft problem we can increase the Transition length upto 15mm.

Section criterias, fixations & mounting with BIW

Section criterias, fixations & mounting with BIW

Section criterias, fixations & mounting with BIW

Section criterias, fixations & mounting with BIW

Section criterias, fixations & mounting with BIW

Section criterias, fixations & mounting with BIW

Section criterias, fixations & mounting with BIW

Section criterias, fixations & mounting with BIW

General gap & biting conditions

General gap & biting conditions

General gap & biting conditions

General gap & biting conditions

General gap & biting conditions

You might also like