Communications Systems | LBB 190x/10 and LBB 191x/10 Plena Mixer Amplifiers

LBB 190x/10 and LBB 191x/10 Plena Mixer Amplifiers

www.boschsecurity.com

Range of single and dual zone mixer amplifiers from 30 W to 120 W Four low-noise balanced inputs for microphone or line Selectable priority & VOX switching on microphone input 1 Optional 2-tone chime to precede announcements VOX activated emergency override

u u

The Plena mixer amplifier is a versatile, highperformance unit with four mono microphone inputs and a music input. It fulfills a wide variety of public address requirements at a surprisingly low cost. Functions All input channels have a phantom power supply to provide power to condenser microphones and selectable speech filters for improved intelligibility. Input channels 3 and 4 can also be switched to line sensitivity. Separate music inputs are available with their own input selector and volume control. Input channel 1 can take priority over all other microphone and music inputs. Contact closure on the 5-pin DIN connector, or if the signal level on channel 1 exceeds a predefined value (VOX) will activate priority. A 2-tone chime can be configured to precede a priority announcement. A telephone or emergency input with VOX activation and its own preset volume control overrides all other input.

Loop through input and output connections enable external sound processing equipment, such as an equalizer or the Plena feedback suppressor, to be connected between the preamplifier and the power amplifier stages. An LED VU-meter monitors the master output. The unit also has a tape output channel. The Plena mixer amplifiers come in a range of maximum output power. This power is directly available on 70 V and 100 V constant voltage connections and on a low impedance connection for an 8 ohm load. Moreover, the amplifiers have a separate 70 V / 100 V call-only output channel for addressing areas where only priority announcements are required, and a 70 V / 100 V mix-only output channel for areas where no priority announcements should be heard. The call-only output can also be used for 3-wire remote, volume control override. For more output power than the built-in power stage can deliver, additional Plena power amplifiers can be connected to the balanced line output in a loopthrough arrangement.

2 | LBB 190x/10 and LBB 191x/10 Plena Mixer Amplifiers

The LBB 1914/10 offers the same functionality as the LBB 1912/10 but also has two front-panel switches to direct the amplifier output to two separate zones. This is useful when certain announcements or background music should not be heard in part of a building. Priority calls, however, are always routed to both zones. Controls and indicators Front
LED power meter Power on LED Master volume control knob Four volume control knobs for mic inputs Three knobs for BGM volume, treble, and bass levels BGM source selection knob On/off switch Two zone selection buttons (LBB1914/10 only) EMG input volume control Two mic/line switches Chime on/off switch Mains voltage switch

Installation/configuration notes

LBB 190x/10 and LBB 191x/10 rear view Parts included

Quantity 1 Components LBB 190x/10 Plena Mixer Amplifier or LBB 191x/10 Plena Mixer Amplifier Power cord Set of 19 mounting brackets Installation and User Instructions

Back

1 1 1

Interconnections Front
Headphone jack

Back
Priority mic input (DIN/6.3 mm jack) Mic input (XLR/6.3 mm jack) Two mic/line inputs (XLR/6.3 mm jack) Three audio inputs (2 x cinch) EMG input (screw) Line output (XLR) Tape output (2 x cinch) Insertion input/output (2 x cinch) 24 VDC input Three (five for the LBB 1914/10) loudspeaker outputs (screw)

Technical specifications Electrical

Mains power supply Voltage Inrush current LBB 1903/10 LBB 1906/10 LBB 1912/10, LBB 1914/10 Battery power supply Voltage Current LBB 1903/10 LBB 1906/10 LBB 1912/10, LBB 1914/10 Performance Frequency response Distortion Bass control Treble control Dynamic range Mic input 50 Hz to 20 kHz (+1 / -3 dB at -10 dB ref. rated output) <1% at rated output power, 1 kHz -8 / +8 dB at 100 Hz -8 / +8 dB at 10 kHz 100 dB 2x 1.6 A 3A 6A 24 VDC, +15% / -15% 4.5 / 9 A (230 / 115 VAC) 5 A / 10 A (230 / 115 VAC) 8 / 16 A (230 / 115 VAC) 230/115 VAC, 10%, 50/60 Hz

Certifications and approvals

Safety Immunity Emission Region Europe acc. to EN 60065 acc. to EN 55103-2 acc. to EN 55103-1 Certification CE

3 | LBB 190x/10 and LBB 191x/10 Plena Mixer Amplifiers

Connector 1 Connector 2 Sensitivity Impedance S/N (flat at max volume) S/N (flat at min volume/ muted) CMRR Headroom Speech filter Phantom power supply VOX (input 1 only) Mic/line input Connector 3, 4 Sensitivity Impedance S/N (flat at max volume) S/N (flat at min volume/ muted) CMRR Headroom Speech filter Phantom power supply Music input Connector Sensitivity Impedance S/N (flat at max volume) S/N (flat at min volume/ muted) Headroom Emergency / telephone Connector Sensitivity Impedance S/N (flat at max volume) VOX

5-pin DIN, 6.3 mm phone jack, balanced, with phantom power 3-pin XLR, 6.3 mm phone jack, balanced, with phantom power 1 mV >1 kohm 63 dB >75 dB >40 dB (50Hz-20kHz) >25 dB -3 dB at 315 Hz, high-pass, 6 dB/oct 16 V via 1.2 kohm attack time 150 ms; release time 2 s 2x 3-pin XLR, 6.3 mm phone jack, balanced, with phantom power 1 mV (mic); 200 mV (line) >1 kohm (mic); >5 kohm (line) >63 dB (mic); >70 dB (line) >75 dB >40 dB (50 Hz to 20 kHz) >25 dB -3 dB at 315 Hz, high-pass, 6 dB/oct 16 V via 1.2 kohm (mic) 1x Cinch, stereo converted to mono 200 mV 22 kohm >70 dB >75 dB >25 dB 1x Screw terminals 100 mV to 1 V, adjustable >10 kohm >65 dB 50 mV threshold ; 150 ms attack time; 2 s release time

Loop through input Connector Nominal level Impedance Master line output Connector Nominal level Impedance Tape output Connector Nominal level Impedance Loop through output Connector Nominal level Impedance Loudspeaker output 70/100 V Connector Power LBB 1903/10 LBB 1906/10 LBB 1912/10, LBB 1914/10 Loudspeaker output 8 ohm Connector Power LBB 1903/10 LBB 1906/10 LBB 1912/10, LBB 1914/10 Power reduction on 24 V

1x Cinch 1V >10 kohm 1x 3-pin XLR, balanced 1V <100 ohm 1x Cinch, 2 x mono 350 mV 1.5 kohm 1x Cinch 1V <100 ohm

Screw, floating Max / rated 45 / 30 W 90 / 60 W 180 / 120 W

Screw, floating

16 V (30 W) 22 V (60 W) 31 V (120 W) 1 dB

Power consumption
Mains operation max LBB 1903/10 LBB 1906/10 LBB 1912/10, LBB 1914/10 24 V operation max LBB 1903/10 1.6 A 100 VA 200 VA 400 VA

4 | LBB 190x/10 and LBB 191x/10 Plena Mixer Amplifiers

LBB 1906/10 LBB 1912/10, LBB 1914/10

3A 6A

Mechanical
Dimensions (H x W x D) Weight LBB 1903/10 LBB 1906/10 LBB 1912/10, LBB 1914/10 Mounting Color Approx. 5 kg Approx. 8.5 kg Approx. 10.5 kg Standalone, 19" rack Charcoal 100 x 430 x 270 mm (19" wide, 2U high)

Environmental
Operating temperature Storage temperature Relative humidity Acoustic noise level of fan -10 C to +45 C (+14 F to +113 F) -40 C to +70 C (-40 F to +158 F) <95% <48 dB SPL at 1 m (max output)

Ordering information
LBB 1903/10 Plena Mixer Amplifier

45W/30 W, 100 VA, 4.5 A / 9 A (230 Vac/ 150 Vac)

Order number LBB1903/10 LBB 1906/10 Plena Mixer Amplifier

90 W / 60 W, 200 VA, 5 A / 10 A (230 Vac/ 150 Vac)

Order number LBB1906/10 LBB 1912/10 Plena Mixer Amplifier

180 W/120 W, 100 VA, 8 A / 16 A (230 Vac/ 150 Vac)

Order number LBB1912/10 LBB 1914/10 Plena Mixer Amplifier

180 W /120 W, 100 VA, 8 A / 16 A (230 Vac/ 150 Vac); 2 zone

Order number LBB1914/10

Represented by: Americas: Bosch Security Systems, Inc. 12000 Portland Avenue South Burnsville MN 55337, USA Phone: +1-800-392-3497 Fax: +1-800-955-6831 [email protected] www.boschsecurity.com Europe, Middle East, Africa: Bosch Security Systems B.V. P.O. Box 80002 5617 BA Eindhoven, The Netherlands Phone: + 31 40 2577 284 Fax: +31 40 2577 330 [email protected] www.boschsecurity.com Asia-Pacific: Robert Bosch (SEA) Pte Ltd, Security Systems 11 Bishan Street 21 Singapore 573943 Phone: +65 6571 2808 Fax: +65 6571 2699 [email protected] www.boschsecurity.asia China: America Latina: Bosch (Shanghai) Security Systems Ltd. Robert Bosch Ltda Security Systems Division 201 Building, No. 333 Fuquan Road Via Anhanguera, Km 98 North IBP CEP 13065-900 Changning District, Shanghai Campinas, Sao Paulo, Brazil 200335 China Phone: +55 19 2103 2860 Phone +86 21 22181111 Fax: +55 19 2103 2862 Fax: +86 21 22182398 [email protected] www.boschsecurity.com.cn www.boschsecurity.com

Bosch Security Systems 2012 | Data subject to change without notice 1886768267 | en, V1, 23. Nov 2012