TM 11-5820-489-20P
TECHNICAL MANUAL
ORGANIZATIONAL MAINTENANCE REPAIR PARTS AND SPECIAL TOOLS LISTS FOR
CONTROL GROUP AN/GRA-6 (NSN 5820-00-644-4554)
HEADQUARTERS,
DEPARTMENT
OF
THE
ARMY JULY 1977
*TM 11-5820-489-20P T ECHNICAL M A N U A L No. 11-5820-489-20P HEADQUARTERS DEPARTMENT OF THE ARMY W ASHINGTON , DC, 15 July 1977
ORGANIZATIONAL MAINTENANCE REPAIR PARTS AND SPECIAL TOOLS LISTS FOR
CONTROL GROUP AN/GRA-6 (NSN 5820-00-644-4554)
Current as of 31 March 1977
REPORTING OF ERRORS You can improve this manual by recommending improvements using DA Form 2028-2 (Test) located in the back of the manual. Simply tear out the selfaddressed form, fill it out as shown on the sample, fold it where shown, and drop it in the mail. If there are no blank DA Form 2028-2 (Test) in the back of your manual, use the standard DA Form 2028 (Recommended Changes to Publications and Blank Forms) and forward to the Commander, US Army Electronics Command, ATTN: DRSEL-MA-Q, Fort Monmouth, NJ 07703. In either case a reply will be furnished direct to you.
SECTION I. II. Group 00 01 02 S ECTION III. IV.
Page Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Repair parts list . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Control Group AN/GRA-6 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Remote Control C-433/GRC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Local Control C-434/GRC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Special tools list (Not applicable) National stock number and part number index . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
Illus Figure
1 2 3-5
*This manual supersedes TM 11-5820-489-20P, 4 June 1969.
TM 11-5820-489-20P
SECTION I INTRODUCTION
1. Scope
This manual lists spares and repair parts; special tools; special test, measurement, and diagnostic equipment (TMDE), and other special support equipment required for performance of organizational maintenance of the AN/GRA-6. It authorizes the requisitioning and issue of spares and repair parts as indicated by the source and maintenance codes.
2. General
This Repair Parts and Special Tools List is divided into the following sections: a. Section II. Repair Parts List. A list of spares and repair parts authorized for use in performance of maintenance. The list also includes parts which must be removed for replacement of the authorized parts. Parts lists are composed of functional groups in numeric sequence, with the parts in each group listed in figure and item number sequence. b. Section III. Special Tools List. Not applicable. c. Section IV. National Stock Number and Part Number Index. A list, in National item identification number (NIIN) sequence, of all National stock numbers (NSN) appearing in the listings, followed by a list, in alphameric sequence, of all part numbers appearing in the listings. National stock numbers and part numbers are cross-referenced to each illustration figure and item number appearance.
NOTE Cannibalization or salvage may be used as a source of supply for any items source coded above except those coded XA and aircraft support items as restricted by AR 700-42 (2) Maintenance code. Maintenance codes are assigned to indicate the levels of maintenance authorized to USE and REPAIR support items. The maintenance codes are entered in the third and fourth positions of the Uniform SMR Code format as follows: (a) The maintenance code entered in the third position will indicate the lowest maintenance level authorized to remove, replace, and use the support item. The maintenance code entered in the third position will indicate the following level of maintenance:
Code Application/Explanation
Support item is removed, replaced, used at the organizational level. (b) The maintenance code entered in the fourth position indicates whether the item is to be repaired and identifies the lowest maintenance level with the capability to perform complete repair (i.e., all authorized maintenance functions). This position will contain one of the following maintenance codes:
Code Application/Explanation
3. Explanation of Columns
a. Illustration. This column is divided as follows: (1) Figure number. Indicates the figure number of the illustration on which the item is shown. (2) Item number. The number used to identify item called out in the illustration. b. Source, Maintenance, and Recoverability (SMR) Codes. (1) Source code. Source codes indicate the manner of acquiring support items for maintenance, repair, or overhaul of end items. Source codes are entered in the first and second positions of the Uniform SMR code format as follows:
Code Definition
The lowest maintenance level capable of complete repair of the support item is the direct support level. Nonreparable. No repair is authorized. codes disporecovof the
(3) Recoverability code. Recoverability are assigned to support items to indicate the sition action on unserviceable items. The erability code is entered in the fifth position Uniform SMR Code format as follows:
Recoverability codes Definition
PA Item procured and stocked for anticipated or known usage.
Nonreparable item. When unserviceable, condemn and dispose at the level indicated in position 3. F Reparable item. When uneconomically reparable, condemn and dispose at the direct support level. c. National Stock Number. Indicates the National stock number assigned to the item and will be used for requisitioning purposes.
TM 11-5820-489-20P d. Part Number. Indicates the primary number used by the manufacturer (individual, company, firm, corporation, or Government activity), which controls the design and characteristics of the item by means of its engineering drawings, specifications, standards, and inspection requirements to identify an item or range of items. NOTE When a stock-numbered item is requisitioned, the repair part received may have a different part number than the part being replaced. e. Federal Supply Code for Manufacturer (FSCM). The FSCM is a 5-digit numeric code listed in SB 708-42 which is used to identify the manufacturer, distributor, or Government agency, etc. f. Description. Indicates the Federal item name and, if required, a minimum description to identify the item. g. Unit of Measure (U/M). Indicates the standard of the basic quantity of the listed item as used in performing the actual maintenance function. This measure is expressed by a two-character alphabetical abbreviation (e.g., ea, in, pr, etc). When the unit of measure differs from the unit of issue, the lowest unit of issue that will satisfy the required units of measure will be requisitioned. h. Quantity Incorporated in Unit. Indicates the quantity of the item used in the breakout shown on the illustration figure, which is prepared for a functional group, subfunctional group, or an assembly. to those published in TM 11-5820-489-34P. Only those parts assigned the third position SMR maintenance SMR code C or O are listed in the tabular listing; therefore, there may be a break in the item number sequence. Only illustrations containing organizational authorized items appear in this manual.
5. How to Locate Repair Parts
a. When National stock number or part number is unknown. (1) First. Using the table of contents, determine the functional group within which the item belongs. This is necessary since illustrations are prepared for functional groups and listings are divided into the same groups. (2) Second. Find the illustration covering the functional group to which the item belongs. (3) Third. Identify the item on the illustration and note the illustration figure and item number of the item. (4) Fourth. Using the Repair Parts Listing, find the figure and item number noted on the illustration. b. When National stock number or part number is known. (1) First. Using the Index of National Stock Numbers and Part Numbers, find the pertinent National stock number or part number. This index is in NIIN sequence followed by a list of part numbers in alphameric sequence, cross-referenced to the illustration figure number and item number. (2) Second. After finding the figure and item number, locate the figure and item number in the repair parts list.
4. Special Information
a. The following publication pertains to AN/ GRA-6 and its components: TM 11-5038, Control Group AN/GRA-6. b. The illustrations in this manual are identical
6. Abbreviations
Not applicable.
(Next printed page is 4.)
TM 11-5820-489-20P
Figure 1.
Control Group AN/GRA-6.
SECTION II (1) ILLUSTRATION (a) (b) FIG ITEM NO. NO. (2) (3) NATIONAL STOCK NUMBER (4) (5)
TM11-5820-489-20P (6) DESCRIPTION PART NUMBER FSCM GROUP 00 CONTROL GROUP AN/GRA-6 USABLE ON CODE U\M (7) (8) QTY INC IN UNIT
SMR CODE
1 1 1 1
1 2 3 4
PAOZZ PAOFF PAOZZ PAOFF
5820-00-404-6885 CW-189/GR 5820-00-170-5171 C-433/GRC 5965-00-163-9947 H-33/PT 5820-00-170-4781 C-434/GRC
80063 80058 81349 80058
BAG REMOTE CONTROL HANDSET LOCAL CONTROL
EA EA EA EA
1 1 1 1
TM 11-5820-489-20P
Figure 2.
Remote Control C-433/GRC.
SECTION II (1) ILLUSTRATION (a) (b) FIG ITEM NO. NO. (2) (3) NATIONAL STOCK NUMBER (4) (5)
TM11-5820-489-20P (6) DESCRIPTION PART NUMBER FSCM GROUP 01 REMOTE CONTROL C-433/GRC USABLE ON CODE U\M (7) (8) QTY INC IN UNIT
SMR CODE
2 2
2 6
PAOZZ PAOZZ
5355-00-656-1358 MS91525-2 6240-00-223-9100 NE51
96906 95412
KNOB LAMP,GLOW
EA EA
1 1
TM 11-5820-489-20P
Figure 3.
Local Control C-434/GRC.
SECTION II (1) ILLUSTRATION (a) (b) FIG ITEM NO. NO. (2) (3) NATIONAL STOCK NUMBER (4) (5)
TM11-5820-489-20P (6) DESCRIPTION PART NUMBER FSCM GROUP 02 LOCAL CONTROL C-434/GRC USABLE ON CODE U\M (7) (8) QTY INC IN UNIT
SMR CODE
PAOZZ
5999-00-221-6559 SCB41623
80063
CAP,ELECTRICAL
EA
TM 11-5820-489-20P
Figure 4.
Local Control C-434/GRC, Over-All View.
10
SECTION II (1) ILLUSTRATION (a) (b) FIG ITEM NO. NO. 4 4 4 4 5 7 8 9 (2) (3) NATIONAL STOCK NUMBER (4) (5)
TM11-5820-489-20P (6) DESCRIPTION PART NUMBER FSCM 96906 80063 95412 80063 KNOB COVER,ELEC CONN LAMP GLOW KNOB USABLE ON CODE U\M EA EA EA EA (7) (8) QTY INC IN UNIT 1 1 1 1
SMR CODE PAOZZ PAOZZ PAOZZ PAOZZ
5355-00-656-1358 MS91525-2 5935-00-258-4449 SCDL107431 6240-00-223-9100 NE51 5805-00-399-7398 SCB42442
11
TM 11-5820-489-20P
Figure 5.
Local Control C-434/GRC, Disassembled View.
12
SECTION II (1) ILLUSTRATION (a) (b) FIG ITEM NO. NO. 5 3 (2) (3) NATIONAL STOCK NUMBER (4) (5)
TM11-5820-489-20P (6) DESCRIPTION PART NUMBER FSCM 80063 COVER,BATTERY USABLE ON CODE U\M EA (7) (8) QTY INC IN UNIT 1
SMR CODE PAOZZ
6140-00-244-5151 SCC42415
13
SECTION IV
TM11-5820-489-20P
NATIONAL STOCK NUMBER AND PART NUMBER INDEX NOTE: LATEST NATIONAL STOCK NUMBER AND PART NUMBER ASSIGNMENTS ARE INCLUDED AT END OF INDEX FIG. ITEM FIG. ITEM STOCK NUMBER NO. NO. STOCK NUMBER NO. NO. 5965-00-163-9947 5820-00-170-4781 5820-00-170-5171 5999-00-221-6559 6240-00-223-9100 PART NUMBER 1 1 1 3 2 FIG. NO. 3 4 2 4 6 ITEM NO. 6240-00-223-9100 6140-00-244-5151 5805-00-399-7398 5820-00-404-6885 4 5 4 1 8 3 9 1
FSCM
PART NUMBER
FSCM
FIG. NO.
ITEM NO.
C-433/GRC 80058 1 2 C-434/GRC 80058 1 4 CW-189/GR 80063 1 1 H-33/PT 81349 1 3 NE51 95412 2 6 NE51 95412 4 8 LATEST NATIONAL STOCK NUMBER ASSIGNMENTS FIGURE ITEM STOCK NUMBER NO. NO. 5935-00-258-4449 4 5355-00-656-1358 2 5355-00-656-1358 4 LATEST PART NUMBER ASSIGNMENTS FIG. PART NUMBER FSCM NO. MS91525-2 MS91525-2 SCDL107431 96906 96906 80063 2 4 4 7 2 5 ITEM NO. 2 5 7
SCB41623 SCB42442 SCC42415
80063 80063 80063
3 4 5
4 9 3
14
TM 11-5820-489-20P
By Order of the Secretary of the Army: BERNARD W. ROGERS General, United States Army Chief of Staff
Official: PAUL T. SMITH Major General, United States Army The Adjutant General
Distribution: To be distributed in accordance with DA Form 12-51, Organizational maintenance requirements for AN/GRA-6.
PIN : 030682-000
